Alloy wheels Alaris - a popular choice among owners ŠKODA, combining German quality, stylish design and affordable price. Group owned brand Ronal Group, offers a wide range of models suitable for most cars of the Czech manufacturer - from compact Fabia up to overall Kodiaq. However, incorrect selection of parameters can lead to problems with the suspension, ABS, or even denial of warranty service.
In this article we will look at how choose the right Alaris wheels for your ŠKODA, what to look for when purchasing, and what nuances to consider when installing. You will learn about standard sizes for each model, fastening features (PCD, ET, DIA), as well as how to avoid common mistakes when selecting. We will pay special attention to issues of compatibility with winter tires and driver assistance systems (ESP, Hill Hold).
Why Alaris wheels are suitable for ŠKODA: brand advantages
Brand Alaris positioned as a premium line in the portfolio Ronal Group - one of the largest European manufacturers of wheel rims. Unlike budget analogues, wheels undergo strict control at the casting and painting stages, which guarantees:
- 🔹 Reduced weight due to optimized design (10–15% lighter than standard ŠKODA steel wheels).
- 🔹 Corrosion resistance thanks to multi-layer coating (including powder painting and varnishing).
- 🔹 ADAS Compatible (for example, tire pressure sensors TPMS).
- 🔹 Warranty 2–5 years (depending on the model and region of sale).
Important: disks Alaris certified according to the standard TÜV and undergo crash tests to ensure compliance ŠKODA Auto. This means that their installation will not void the vehicle's warranty (as long as the recommended parameters are followed).
⚠️ Attention: Some ŠKODA dealers may refuse warranty repairs to the suspension if the offset (ET) of the discs differs from the factory one by more than ±5 mm. Before purchasing, check the permissible deviations for your model!
Compatibility table: Alaris wheel sizes for ŠKODA models
Each model ŠKODA has unique requirements for wheel rims. Below is a table with recommended parameters for popular cars. Please note: values may vary depending on year of manufacture and equipment.
| Model ŠKODA | Diameter (inches) | Width (inches) | PCD (bolt pattern) | ET (reach, mm) | DIA (hub, mm) |
|---|---|---|---|---|---|
| Octavia (A8, 2020–present) | 16–19 | 6.5–8.5 | 5×112 | 35–45 | 57.1 |
| Kodiaq (2017–present) | 17–20 | 7.0–9.0 | 5×112 | 38–48 | 57.1 |
| Karoq (2017–present) | 16–19 | 6.5–8.0 | 5×112 | 35–45 | 57.1 |
| Superb (3V, 2015–present) | 16–19 | 7.0–8.5 | 5×112 | 38–48 | 57.1 |
| Fabia (NJ, 2021–present) | 15–17 | 6.0–7.0 | 5×100 | 38–45 | 57.1 |
Critical nuance: for models on the MQB platform (Octavia A8, Kodiaq, Karoq), it is allowed to install discs with PCD 5×112, but only with center rings (hubs) with a diameter of 57.1 mm. The use of discs with PCD 5×100 will lead to uneven wear of hub bearings!
- Octavia
- Kodiaq
- Karoq
- Superb
- Fabia
- Other
How to choose the right Alaris discs: step-by-step instructions
Selection of discs is not only a matter of aesthetics, but also of safety. An error in parameters can lead to vibrations at speed, premature wear of the rubber or even loss of control. Follow this algorithm:
- Define the basic parameters your car:
- 📏 The size of the regular disks (indicated in the manual for operation or on the sticker in the doorway).
- 🔧 Blurging (PCD) and hub diameter (DIA).
- ⚖️ Acceptable offset (ET) - deviation of ± 3 mm from the factory value is considered critical.
- Check compatibility with tires:
- 🔄 The width of the disc should correspond to the width of the rubber (for example, a 7.5J-8.0J disc will suit a tire 225/50 R17).
- ❄️ For winter tires, it is recommended to fly 5-10 mm less (increases stability in snow).
- Consider the features of the suspension:
- 🚗 For vehicles with air suspension (e.g., Superb Laurin & Klement) reinforced spoke discs are required.
- 🔩 When installing rims larger than 18 inches, check the gap between the tire and shock absorber when the steering wheel is turned completely.
☑️ Checking before buying Alaris discs
Example: for ŠKODA Octavia RS (2022) with factory discs 18×7.5J ET45 will fit Alaris Pulsar 18×8.0J ET42, but you will need to use 225/45 R18 rubber instead of the regular 235/40 R18 (due to the increased disk width).
Top 5 Alaris Disc Models for ŠKODA: Review and Reviews
Ruler Alaris It includes more than 50 models, but ŠKODA The following options are particularly popular:
- Alaris Pulsar
Design: 5 spokes with Y-shaped inserts. Suitable for Octavia and Superb. The 17-inch version weighs 8.2 kg (12 percent lighter than the ŠKODA standard drive). Reviews note the resistance to chips when driving on gravel.
- Alaris Turbo
Design: 10 spokes with turbine effect. Popular among owners Kodiaq Thanks to improved cooling of the brake mechanisms. The disadvantage is the difficulty of balancing due to the asymmetrical shape.
- Alaris Aeros
Design: 7 spokes with aeroelements. Optimized for models with a system Dynamic Chassis Control (DCC). In tests, it showed a decrease in fuel consumption by 0.3 l / 100 km due to reduced resistance.
The full catalog can be found on the official website Ronal Group. Please note: some models (eg Alaris Pulsar Black Edition) are ordered only with a waiting period of up to 4 weeks.
⚠️ Attention: Discs with a glossy coating (for example, Alaris Turbo Silver Polished) require careful care - they can not be washed with brushes or harsh chemicals (for example, acid-based products). Use only microfiber wipes and pH-neutral shampoos.
How to distinguish the original Alaris discs from a fake?
The original Alaris discs have:
- Brand logo engraved with a laser (not a sticker!) on the inside.
- Serial number starting with the letters "ALR".
- Certificate of conformity TÜV complete (with hologram).
- A pack of hard cardboard with embossed.
Counterfeiting is often more rough painting, the absence of center rings in the kit and weight 10-15% higher than claimed.
Installation of Alaris disks: step-by-step process and possible errors
Even properly sized drives can cause problems if they are installed incorrectly. Here are the key installation steps:
- Preparation:
- 🔧 Clean the hub of dirt and rust (use a copper brush).
- 🧲 Check the ABS magnetic valve for damage (especially relevant for the use of the ABS magnetic valve). Kodiaq with the system Off-Road Mode).
- Installation:
- 🔩 Tighten the bolts cross-cross in 3 stages (preliminary - 50 N·m, then 90 N·m, finally - 110 N·m for models with PCD 5×112).
- 🎯 Use the dynamometer key! The bolts pulling leads to the disk deformation.
- Balancing:
- ⚖️ For discs with a diameter of 18+ inches, balancing is recommended taking into account the weight of the bus and disk separately (the “split balancing” method).
- 🔄 After balancing, check the beating of the disk on the stand - the permissible value: no more than 0.5 mm.
Typical installation errors:
- ❌ Use of old bolts (they deform when used repeatedly).
- ❌ Ignoring the center rings (leads to vibrations at a speed of 100+ km/h).
- ❌ Balancing only the bus without disc (relevant for discs with asymmetrical design, for example, Alaris Turbo).
1. Correctness of tightening of bolts (they could weaken after the first 100 km).
2. The condition of brake discs – new wheels can highlight their beating.
3. Balancing: Alaris discs with asymmetric spokes require special hardware (e.g. Hunter GSP9700).
Compatible with driver assistance systems (ESP, Hill Hold, TPMS)
Modern ŠKODA They are equipped with complex electronic systems that can conflict with non-standard disks. Here's what you need to know:
- 🔄 ESP (Electronic Stabilization Program): Sensitive to offset change (ET). If the ET differs from the factory by more than 10 mm, the system may falsely fire on corners.
- 🏔️ Hill Hold (Help to move up): It works correctly only when the factory diameter of the disks is observed. An increase in diameter by 1-2 inches can cause a delay in operation.
- 🚨 TPMS (Tyre Pressure Control): Tyre pressure on discs Alaris It may differ from the standard due to different air volume (especially with an increased disk width). After installation, recalibration of the system through the menu is required
CAR → Tyre Pressure → Store.
For vehicles with adaptive cruise control (CVC)ACC) it is important that the radar sensors are not overlapped by the disc spokes. For example, for ŠKODA Superb with ACC Discs with a closed design are not recommended (for example, Alaris Monolith).
Before buying Alaris discs for ŠKODA with ADAS (Driver Assistance) systems, be sure to check their compatibility through the service. ŠKODA Original Accessories Or at the official dealer. Incompatible disks can disable functions Lane Assist or Traffic Jam Assist!
Owner reviews: pros and cons of Alaris drives on ŠKODA
Analysis of reviews on forums (for example, SkodaClub.ru or Drive2.ru) shows that most owners ŠKODA happy with the discs AlarisBut there are nuances:
| Car model | Alaris disc model | Pros | Cons |
|---|---|---|---|
| Octavia RS | Alaris Pulsar 18×8.0 | Lightness, improved acceleration dynamics | Difficult to wash (many indentations) |
| Kodiaq Scout | Alaris Turbo 19×8.5 | Excellent brake cooling. | High noise speed of 120+ km/h |
| Superb Sportline | Alaris Aeros 20×8.5 | Stylish design, low weight | Price (from 120 000 rubles). per kit |
The overall satisfaction rating is 4.5/5. The main claims relate to:
- 💰 High price (by 20-30% more expensive than analogues from the Replica or Dezent).
- 🛠️ Difficulty balancing (requires an experienced master).
- 🔧 The absence of center rings in some sets (have to buy separately).
FAQ: Frequent questions about Alaris discs for ŠKODA
Can I put Alaris discs on ŠKODA with air suspension?
Yes, but only models with reinforced spokes (for example, Alaris Pulsar Reinforced). Important: maximum diameter for cars with pneumonia - 19 inches (for pneumonia) Kodiaq and Superb). Exceeding this size can lead to contact of the tire with suspension elements under complete compression.
Which flight (ET) to choose for winter drives?
For winter operation, it is recommended to fly 5-10 mm less than the factory. For example, if the standard ET = 45 mm, choose discs with ET 35-40 mm. This will improve snow resistance, but may slightly increase the load on the hub bearings. For ŠKODA with all-wheel drive (4×4), the deviation of ET should not exceed ± 3 mm.
Do I need to reflash the ECU after installing Alaris disks?
Flashing is not required, but system adaptations must be reset. ESP and TPMS. This can be done through a diagnostic scanner (for example, VCDS) or at the ŠKODA service centre. The cost of the procedure is about 1,500 rubles.
Which Alaris discs are suitable for the ŠKODA Enyaq (electric car)?
For Enyaq and Enyaq Coupé Compatible discs with PCD 5×112, DIA 57.1 mm and offset ET 35–45 mm. Feature: due to the large weight of the car (about 2 tons), models with a load of at least 750 kg per disk are recommended (for example, Alaris Pulsar EV). Also check compatibility with the regenerative braking system – some discs may overlap brake temperature sensors.
What if the ABS icon catches fire after Alaris disks are installed?
The reason may be:
- Incorrect installation of center rings (disturbed sensor ABS).
- The hit of metal shavings on the sensor (when drilling holes under bolts).
- Disk incompatibility with magnetic ring ABS (relevant for models with the system) Off-Road).
Solution: Check the gaps between the disc and the sensor (should be at least 1 mm), clean the sensor, use the box rings if necessary.