Choosing wipers for ŠKODA Octavia Tour - a task that at first glance seems simple, but in reality hides a lot of nuances. Incorrectly selected blades not only clean the windshield worse, but can also damage it or the wiper mechanism itself. This problem is especially relevant for owners Octavia Tour - a station wagon with an increased glass area, where the quality of cleaning directly affects visibility in rain or snow.

In this article we will look at exact dimensions of wipers for all generations Octavia Tour (including restyled versions), original articles from ŠKODA/VW, proven analogues and we will give step-by-step instructions for replacement. You will also find out what frameless or hybrid brushes are better suited for winter use, and how to avoid common mistakes when purchasing. If you've ever experienced wipers jumping on the glass or leaving streaks, you'll find a solution here.

Wiper wiper sizes on the ŠKODA Octavia Tour: table by generation

The first thing to start with is to determine exact brush size for your version Octavia Tour. Dimensions may vary even within the same generation, especially when it comes to restyled models or cars with the option Panoramic Sunroof (panoramic roof). Below is an updated table taking into account all modifications.

Generation Years of manufacture Front wiper size (driver/passenger) Rear wiper size Notes
Octavia Tour 1Z (A5) 2004–2013 600 mm / 600 mm 400 mm Symmetrical brushes, suitable for all configurations
Octavia Tour 5E (A7, pre-restayl) 2013–2017 650 mm / 450 mm 400 mm Asymmetrical dimensions, check installation side!
Octavia Tour 5E (A7, facelift) 2017–2020 650 mm / 450 mm 400 mm No changes, but variations with a panoramic roof are possible
Octavia Tour 4-gen (NX, since 2020) 2020–present 650 mm / 400 mm 350 mm Reduced passenger blade size, shorter rear wiper

⚠️ Attention: On models with panoramic roof (Panoramic Sunroof) the rear wiper can be 50 mm shorter than the standard one. Check the size using the VIN code or visually measure the old brush.

If your Octavia Tour refers to a rare configuration (for example, RS or Scout), we recommend checking the original catalog ETKA or use online services like VIN decoder for precise identification of articles.

Original ŠKODA wipers: part numbers and where to buy

Original windshield wiper blades from ŠKODA (or VW, since they are unified) guarantee a perfect fit and a long service life. However, their prices are often inflated, and in some regions originals are difficult to find. Below are the current articles for different generations Octavia Tour:

  • 🔧 1Z (A5): 6Q1 955 425 A (driver), 6Q1 955 426 A (passenger), 6Q1 955 427 A (rear)
  • 🔧 5E (A7, pre-restayl): 5Q1 955 425 A / 5Q1 955 426 A
  • 🔧 5E (A7, facelift): the same articles, but updated versions with a mark are possible B or C
  • 🔧 4-gen (NX): 5Q0 955 425 J / 5Q0 955 426 J (rear - 5Q0 955 427 J)

You can buy original wipers:

  • 🛒 At official dealerships ŠKODA (guaranteed authenticity, but high price).
  • 🛒 On sites like Exist.ru, Autodoc or EMEX (search by article number, check the seller's reviews).
  • 🛒 In spare parts stores marked "OEM" (for example, Bosch or Hella can supply originals under their own brand).
⚠️ Attention: There are many counterfeits of original items on the market. Pay attention to the packaging (there must be holograms VW Group) and country of production (originals are made in Germany or the Czech Republic).

If the originals seem too expensive, consider certified analogues from trusted brands. More on this in the next section.

📊 What wipers do you prefer?
  • Original (ŠKODA/VW)
  • Premium analogues (Bosch, Hella)
  • Budget (SWF, Champion)
  • Universal (frameless)
  • I don't know

The best equivalent wipers for Octavia Tour: 2026 rating

Analogs of original wipers may be no worse in quality, but are 30–50% cheaper. The main thing is to choose a trusted manufacturer. We tested several brands and ranked the best options for Octavia Tour:

  1. Bosch Aerotwin (series AR650S / AR450S) - frameless brushes with an aerodynamic profile. Excellent handling of ice and snow, service life up to 2 years. Suitable for Octavia Tour 5E and 4-gen.
  2. Hella TwinBlade — hybrid brushes with graphite coating for quiet operation. Articles: HB 650 and HB 450.
  3. Valeo Silencio X-TRM - premium series with technology Silentium for silent operation. Ideal for winter use.
  4. SWF VisioNext - a budget option with a good price/quality ratio. Suitable for Octavia Tour 1Z.
  5. Champion EasyVision — universal brushes with quick fastening EasyClick.

When choosing analogues, pay attention to:

  • 🔹 Mounting type - on Octavia Tour mount is used Hook (U-shaped) or Bayonet (for new models).
  • 🔹 Rubber material — it is better to choose brushes with graphite or silicone coating (they last longer).
  • 🔹 Presence of spoiler — improves downforce at high speeds.

Critically important: on the Octavia Tour 4-gen (from 2020), the passenger brush is 50 mm shorter than on previous generations. Installing a blade with a size of 450 mm instead of 400 mm will result in hitting the windshield pillar!

💡

Before purchasing, measure the length of the old brushes with a tape measure - sometimes, even within the same generation, the dimensions may differ due to options (for example, a rain sensor or a panoramic roof).

How to properly replace wipers on an Octavia Tour: step-by-step instructions

Replacing wipers with ŠKODA Octavia Tour does not require special tools, but there are several nuances that will help you avoid mistakes. Follow this instruction:

☑️ Preparing to replace wipers

Done: 0 / 4
  1. Raise the wipers. Turn off the ignition and carefully lift the wiper arms to the vertical position. Be careful - the springs in the mechanism are very strong!
  2. Remove the old brush.
    • On Octavia Tour 1Z/5E press the fastening latch Hook and slide the brush down.
    • On Octavia Tour 4-gen mount can be used Bayonet — press the button on the side and pull the brush towards you.
  • Install a new brush. Align the mount with the lever and click until it clicks. Make sure that the brush is fixed without play.
  • Check your work. Turn on the wipers at minimum speed and check for any unusual sounds or skipping when cleaning.
  • ⚠️ Attention: Never turn on the wipers if they are in the raised position - this may damage the mechanism or glass! Also, avoid using excessive force when removing the brushes to avoid bending the arms.

    If after replacement the wipers leave streaks, the reason may be:

    • 🔸 Dirty glass (clean with alcohol or a special cleaner).
    • 🔸 Incorrectly installed brush (check symmetry).
    • 🔸 Wear of rubber bands (even new brushes can be defective).
    What to do if the wipers “jump” on the glass?

    This occurs due to uneven wear of the rubber or weak pressure. Try cleaning the glass and brushes of silicone grease (it accumulates over time). If the problem persists, replace the brushes with a model with a reinforced frame (for example, Bosch Twin).

    Common mistakes when choosing and replacing wipers

    Even experienced car owners sometimes make mistakes that lead to poor performance of wipers or their rapid wear. Here are the most common of them:

    • Buying brushes by eye. Wiper sizes per Octavia Tour may differ even within the same generation (for example, with or without a panoramic roof). Always check the chart or measure old brushes.
    • Ignoring fastening type. On new models (Octavia Tour 4-gen) mount is used Bayonet, and on the old ones - Hook. Universal brushes may not be suitable!
    • Saving on quality. Cheap brushes made of low-quality rubber begin to “strip” the glass after 2-3 months, especially in winter.
    • Incorrect installation. If the brush is installed crookedly, it will skip stripes or scratch the glass.
    • Using wipers on ice. This reduces their service life by 2–3 times. Always scrape the ice before turning on the wipers.

    Another typical problem is noise when the wipers operate. It may occur due to:

    • 🔊 Wear of rubber bands (replace brushes).
    • 🔊 Sand or dirt gets into the mechanism (rinse with water under pressure).
    • 🔊 Incorrect installation angle (adjust the position of the levers).
    ⚠️ Attention: If, after replacing the wipers, vertical stripes remain on the glass, this may be a sign glass wear (microcracks) or incorrect geometry of the levers (for example, after an accident). In this case, only polishing the glass or replacing the levers will help.
    💡

    On an Octavia Tour with an automatic wiper activation system (rain sensor), use only graphite-coated blades - they wear out the glass less and do not interfere with the operation of the sensor.

    Wipers for winter: which ones to choose and how to care for them

    Winter operation is a real test for wipers. Frost, ice and reagents quickly damage even expensive brushes. So that the wipers on your Octavia Tour last longer, follow these tips:

    • ❄️ Choose winter brushes. They have a protective cover that prevents icing and a reinforced frame. Good options:
      • Bosch IceTec - with anti-icing coating.
      • Hella WinterBlade — hybrid brushes for extreme conditions.
      • Valeo SnowJam — heated (connected to the cigarette lighter).
    • ❄️ Clean your brushes before winter. Wash them with warm water and soap to remove the silicone grease (it freezes and makes cleaning difficult).
    • ❄️ Don't turn the wipers on frozen glass. This leads to the rubber bands breaking off. Use a scraper or defroster first.
    • ❄️ Raise your wipers at night. If severe frosts are expected, lift the arms vertically and secure them (for example, with foam rubber) so that they do not freeze to the glass.

    If you often drive on the highway in winter, pay attention to brushes with airfoil (for example, Bosch Aerotwin). They press against the glass better at high speeds and do not rise from the air flow.

    Important: on Octavia Tour with the system Rain Light Sensor (rain sensor) do not use brushes with metal elements - they can damage the sensor. Choose only frameless or hybrid models.

    Where to buy wipers for ŠKODA Octavia Tour: trusted stores

    Choosing where to buy wipers is no less important than choosing the blades themselves. Here are proven options where you can buy quality wipers for Octavia Tour:

    Store Pros Cons Average price (pair)
    Autodoc Large selection, convenient selection by model, reviews Long delivery to regions, possible fakes 1 200–2 500 ₽
    Exist Originals and OEM, fast delivery, guarantee Prices are above average 1 500–3 000 ₽
    Wildberries Low prices, fast delivery, often promotions There are many fakes, it is difficult to verify the originality 800–1 800 ₽
    Official dealer ŠKODA 100% original, professional advice Highest prices, limited assortment 2 500–4 000 ₽
    Local spare parts stores You can touch the product and pick it up immediately Overpriced, little selection 1 000–2 200 ₽

    When purchasing online, be sure to check:

    • 📦 Article — it must match the original or be a certified analogue.
    • 📦 Reviews - Pay special attention to complaints about “streaking” or noise.
    • 📦 Expiration date — the rubber in the brushes becomes tanned over time, even if they are new.

    If you are buying wipers for the first time, we recommend choosing a trusted brand (for example, Bosch or Hella) and order them at Exist or Autodoc — there is less risk of running into a fake.

    FAQ: Frequently asked questions about wipers on the ŠKODA Octavia Tour

    Is it possible to install larger wipers than indicated in the table?

    No, this is fraught with several problems:

    • The brush will touch the pillars or the edge of the glass, which will lead to extraneous noise and wear of the mechanism.
    • The load on the wiper motor will increase, which can cause it to overheat.
    • At high speeds, a long brush will press harder against the glass due to aerodynamics.

    The exception is if you install winter brushes with cover, their length can be 10–20 mm longer due to the protective casing.

    How often do you need to change wipers on an Octavia Tour?

    Service life depends on operating conditions:

    • 🔹 Summer: 1–1.5 years (or 20–30 thousand km).
    • 🔹 Winter: 6–12 months (due to ice and reagents).
    • 🔹 Signs of wear: streaks on the glass, creaking, missed areas during cleaning.

    We recommend changing brushes spring and autumn - this way you will be prepared for seasonal precipitation.

    Will wipers from VW Golf fit on Octavia Tour?

    Yes, but with reservations:

    • 🚗 Octavia Tour 1Z (A5) - fully compatible with Golf 5 (same articles).
    • 🚗 Octavia Tour 5E (A7) - compatible with Golf 6/7, but check the size of the rear wiper (on Golf it may be shorter).
    • 🚗 Octavia Tour 4-gen (NX) - compatible with Golf 8, but the mount may differ (Bayonet instead of Hook).

    Always check the article numbers or sizes - even within VW Group there are differences.

    What to do if the windshield wipers on your Octavia Tour start squeaking?

    The creaking is usually caused by one of the following reasons:

    1. Contaminated glass or brushes. Clean the glass with alcohol and wash the brushes with soapy water.
    2. Wear of rubber bands. Try to restore them using silicone grease (applied to the elastic band). If that doesn't help, replace the brushes.
    3. Incorrect installation angle. Remove and reinstall the blades, making sure they fit snugly against the glass.
    4. Sand getting into the mechanism. Pressurize the arm mounting area with water.

    If the squeak only appears in the cold, try winter brushes with graphite coating.

    Is it possible to restore old wipers?

    Yes, but this is a temporary solution. Recovery methods:

    • 🔧 Cleaning. Wash the brushes in warm water and soap, then wipe with alcohol.
    • 🔧 Rubber polishing. Gently go over the rubber with fine sandpaper (P1000), then treat with silicone grease.
    • 🔧 Replacing rubber bands. In some brushes (for example, Bosch) you can buy rubber bands separately and replace them.

    However, it is possible to restore the brushes only 1-2 times. If the rubber becomes dull or cracks, it is better to buy new ones.