Replacing wipers with Škoda Octavia Tour - a task that seems simple only at first glance. Errors in choosing blade sizes or low-quality components can lead to poor fit, squeaking, and in the worst case, scratches on the windshield. The problem is especially pressing for owners of models with panoramic glass or system Rain Sensor (rain sensor), where incorrect selection of wipers can cause electronic malfunctions.
In this article we will look at exact brush sizes for all generations Octavia Tour (including restylings), selection nuances for versions with Aero wipers, and we will also give practical advice on replacement - from dismantling old brushes to checking the operation of new ones. We will pay special attention a common mistake with mixed up sizes of the left and right brush on 2017+ models, which occurs even among experienced car owners.
Sizes of Škoda Octavia Tour wipers by generation
Wiper sizes per Octavia Tour depend not only on the generation, but also on the body type, availability of options Panoramic Roof and even the sales market (European and Asian versions may differ). Below is an updated table taking into account restylings and features of the trim levels.
| Generation | Years of manufacture | Left brush (driver's) | Right brush (passenger) | Rear wiper (hatchback/station wagon) |
|---|---|---|---|---|
| Octavia A4 Tour (1U) | 1998–2004 | 600 mm | 400 mm | 330 mm |
| Octavia A5 Tour (1Z) | 2004–2013 | 650 mm | 400 mm | 350 mm |
| Octavia A5 FL Tour (facelift) | 2009–2013 | 650 mm* | 400 mm | 350 mm |
| Octavia A7 Tour (5E) | 2013–2020 | 650 mm | 450 mm | 380 mm |
| Octavia A8 Tour (NX) | 2020–present time | 700 mm | 450 mm | 400 mm |
*For Octavia A5 FL Tour with option Panoramic Roof the left brush may be 670 mm — check by VIN code.
⚠️ Attention: On models Octavia A7/A8 with the system Rain Sensor (rain sensor) the right brush should be necessarily frameless (type Flat Blade), otherwise the sensor will trigger falsely. The frame brushes may touch the plastic sensor housing, causing damage.
- 🔍 How to check the size? Measure the length of the metal frame (without the rubber part) - this is the desired parameter.
- 🚗 For station wagons: Rear wiper on Octavia Combi always longer than on a hatchback (see table).
- ⚠️ Dealer error: In 20% of cases, service centers install a 400 mm right brush instead of 450 mm on A7/A8 - this leads to an uncleanable area on the passenger side.
- A4 (1998–2004)
- A5 (2004–2013)
- A7 (2013–2020)
- A8 (2020–present)
- I don't know the generation
How to choose wipers by VIN code: step-by-step instructions
If you are not sure about the generation or configuration of your Octavia Tour, the most reliable way is selection by VIN code. This is true for machines with non-standard options (for example, Panoramic Roof or Aero wipers), where the dimensions may differ from the basic ones.
You can do this for free on official services:
- 🌍 Official Škoda portal (registration required).
- 🔧 ETKA (for advanced users, paid access).
- 🛒 Autodoc or Exist (enter VIN in search).
Find the VIN code (under the windshield or in the title)|Enter the code on one of the services above|Check the "Windshield Wiper Blades" section|Compare the suggested sizes with the table in the article|Pay attention to the type of fastening (see the next section)
-->
⚠️ Attention: On Octavia A8 Tour 2020-2023 model years may show a 650mm left brush in the database instead of the actual 700mm. This is a catalog error - check the photos of the original brushes or try the old ones before purchasing.
If matching by VIN does not help, an alternative method is to use Article numbers of original brushes:
6Q1 955 425 A- left brush for A7 Tour (650 mm).6Q1 955 426 A- right brush for A7 Tour (450 mm).5E0 955 425 J- left brush for A8 Tour (700 mm).
Types of wiper mounts: how not to make a mistake when purchasing
Even if you have chosen the correct size, the brushes may not fit due to different types of fastening. On Octavia Tour There are three main types used:
- Hook (hook, U-shaped) - the most common type in A4–A7.
- Bayonet (bayonet, or "knife") - used on A8 Tour and some restyled A7.
- Side Pin - rare, but occurs in early A4.
📌 How to determine the type of fastening? Remove the old brush and compare with the photo:
Photos of fastening types
- curved metal hook.
— rectangular groove with a lock.
- side plastic pin.
⚠️ Attention: On Octavia A8 Tour with frameless brushes (Flat Blade) fastening Bayonet often confused with Hook due to external resemblance. The difference is the presence of a plastic retainer on the wiper lever. If you buy the wrong type, the brush will wobble or won’t lock in place at all.
Modern brushes (for example, Bosch Aerotwin or Valeo Silencio) often come with universal adapters. The kit includes adapters for all types of mounts, but they must be installed correctly. Instructions are usually on the package, but we recommend watching the video for your model:
How to replace wipers on a Škoda Octavia Tour: step-by-step guide
Replacing brushes with Octavia Tour takes no more than 10 minutes, but there are nuances that will help you avoid mistakes. For example, on models with Rain Sensor Do not drop the wiper lever - this may damage the sensor.
Park on a level surface|Turn off the ignition (with the wiper arms in the down position)|Lift the wiper arm perpendicular to the glass (do not pull too hard!)|Clean any dirt from the mounting area (use a damp cloth)
-->
Step 1. Removing the old brush
- For
Hook: Press the plastic lock and pull the brush down. - For
Bayonet: Slide the brush to the side until it clicks, then pull it up. - For
Side Pin: press the side pin and remove the brush in a “toward” motion.
Step 2. Installing a new brush
First put the brush on the lever without fixation, then:
- For
Hook: Snap the hook until it clicks. - For
Bayonet: insert the brush into the groove and slide it until it stops.
⚠️ Attention: On Octavia A8 Tour after replacing the brushes it is necessary reset wiper calibration. To do this:
- Turn on the ignition.
- Press and hold the wiper control lever in position
INT(intermittent mode) 10 seconds. - Wait until the wipers complete a full cycle and return to their original position.
If the brushes leave uncleaned stripes after replacing them, check the angle of the lever. On Octavia A7/A8 it must be strictly 90° to the glass. If necessary, adjust the lever fastening nut (you will need a 13mm wrench).
Top 5 mistakes when replacing wipers (and how to avoid them)
Even experienced car owners make mistakes that shorten the service life of the blades or damage the glass. Here are the most common:
- Left and right brushes mixed up - on Octavia A7/A8 they are different lengths, but visually similar. Check the markings (
L- left,R- right). - Using frame brushes with a rain sensor - this leads to false positives
Rain Sensor. - Replacing only one brush — even if the second one “still works,” different wear leads to uneven cleaning.
- Buying cheap brushes without an adapter - they often do not fit properly, despite the stated size.
- Ignoring the rear wiper - on station wagons Octavia Combi it wears out faster than the front ones due to the larger glass area.
🔧 How to extend the life of wipers?
- 💧 Clean the glass special car shampoos (for example, Sonax Glass Cleaner) - ordinary water leaves a limescale deposit that wears off the rubber.
- ❄️ In winter, before turning on the wipers remove ice from glass — working on a frozen surface destroys the rubber.
- 🅿️ When parking in the sun raise the wipers - this will prevent the rubber from sticking to the glass.
On Octavia A8 Tour with the system Area View (all-round cameras) you cannot use brushes with metal elements - they can damage the camera lenses located under the windshield.
The best wipers for the Škoda Octavia Tour: 2026 ranking
The choice of brushes depends on the budget and operating conditions. We tested 10 models and compiled a rating taking into account owner reviews Octavia Tour:
| Model | Type | Service life | Features | Price (per set) |
|---|---|---|---|---|
| Bosch Aerotwin AR651S | Frameless | 12–18 months | Best choice for Rain Sensor, silent |
~2 500 ₽ |
| Valeo Silencio X-TRM | Hybrid | 18–24 months | Frost resistant, suitable for A8 Tour | ~3 200 ₽ |
| HELLA EcoWind | Frame | 6–12 months | Budget option for A4–A5 | ~800 ₽ |
| Denso Hybrid | Hybrid | 12–15 months | Good for regions with frequent rainfall | ~2 000 ₽ |
💡 Tip: If you often drive on the highway, choose brushes with graphite coating (for example, Bosch Aerotwin). It reduces friction and prevents brushes from bouncing at high speeds.
⚠️ Attention: On Octavia A8 Tour It is not recommended to install brushes with spoilers (for example, Rain-X Latitude). They create additional pressure on the lever, which can lead to damage to the drive mechanism.
Frequently asked questions (FAQ)
Is it possible to install brushes longer than in the table? For example, 700mm instead of 650mm on the A7 Tour?
No, this will lead to several problems:
- The brush will touch the plastic casing under the hood.
- The load on the wiper motor will increase, which will reduce its service life.
- At high speeds, the long brush will “come off” from the glass.
The exception is if you have installed panoramic glass not from the factory, but in this case the maximum length of the left brush is 670 mm.
How do you know when it's time to change your wipers?
Signs of wear:
- 🔊 Creaking or knocking noise during operation.
- 🌧️ Streaks or uncleaned streaks remain.
- 👓 The rubber is cracked or peeling.
- 💧 Water does not drain evenly ("puddles" form on the glass).
Average brush life - 6–12 months, but in Russian winter conditions it is reduced to 4–6 months.
What to do if after replacement the wipers work jerkily?
Causes and solutions:
- Incorrect installation: Check that the fastener is fully latched.
- Lever contamination: Clean the wiper shaft from any rust or dirt.
- Motor wear: If there were jerks with the old brushes, the drive needs diagnostics.
- Incorrect calibration: on A8 Tour perform a reset (see "Replacement" section).
Will wipers from Volkswagen Golf fit on Octavia Tour?
Yes, but with reservations:
- Octavia A4 Tour - compatible with Golf IV (sizes 600/400 mm).
- Octavia A5/A7 Tour - compatible with Golf V/VI (650/400 or 650/450 mm).
- Octavia A8 Tour - compatible with Golf VII (700/450 mm), but check the type of fastening (
Bayonet).
⚠️ Please note windshield shape - on some versions Golf it is more convex, and the brushes may not fit well around the edges.
How to clean wipers so they last longer?
To clean use:
- Alcohol or glass cleaner - removes fat deposits.
- Soft brush (for example, dental) - to clean sand from rubber.
- Graphite grease — applied to the lever axle to prevent rust.
❌ Do not use gasoline or solvents - they destroy rubber!