Wipers for Škoda Superb 2 (2008–2015): exact dimensions, selection and replacement without errors

Replacing wipers with Škoda Superb second generation (3T, body type liftback/combi) is a task that every owner faces after 1–2 years of operation. The original blades wear out, begin to “strip” or creak, and incorrectly selected sizes lead to poor cleaning of the windshield or even damage to the wiper mechanism. In this article - exact dimensions of wipers for all modifications of Superb 2 (including the 2013 facelift), tips for choosing analogues and step-by-step replacement instructions, taking into account typical mistakes.

Feature of the model - asymmetrical dimensions of the front wipers (left and right differ by 5–7 cm), which often becomes the reason for purchasing the wrong brushes. We'll look at how to avoid this problem, which brands offer the best value for money, and why cheap frameless wipers can cost more than the original in the long run. For convenience, the article contains size comparison chart by year of manufacture and body type.

Official wiper sizes for Škoda Superb 2 (2008–2015)

The manufacturer installs on Superb II Windshield wiper blades of the following sizes (length in centimeters):

• 🚗 Front left wiper (driver's side): 65 cm (for all modifications).
• 🚗 Front right wiper: 40 cm (before facelift 2013) or 42 cm (after facelift).
• 🚙 Rear wiper (for station wagon/combi): 35 cm (standard for all model years).

Important: The size of the right wiper depends on the year of manufacture. Cars before 2013 (pre-restayl) were equipped with a brush on 40 cm, and after facelift (2013–2015) - to 42 cm. This is due to changes in the shape of the windshield and the angle of operation of the trapezoid wipers. It is possible to install a brush of the wrong size, but this will lead to:

• ⚠️ Incomplete cleaning (for example, a 40-centimeter brush will not reach the edge of the glass on a restyled model).
• ⚠️ Increased load on the windshield wiper motor (too long blade increases resistance).
• ⚠️ Creak and vibration during work (if the brush is too short or long).

To accurately determine the size, just look under the hood: on the inside of the lid there is usually a sticker with technical data, which indicates the dimensions of the wipers. An alternative way is to measure the old brushes with a tape measure (from edge to edge of the rubber part, excluding the fastening).

How to check wiper size by VIN code

If you are not sure about the sizes or are buying brushes for Superb 2 with mileage, the most reliable way is to check VIN code. This is relevant for restyled models (2013–2015), where the right wiper can be either 40 cm, so 42 cm depending on the configuration.

Instructions:

1. Find the VIN (under the driver's side windshield or on the vehicle registration).
2. Go to the site VIN decoder or use the service ETKA (for VAG dealers).
3. Enter VIN and find partition Windshield Wiper Blades.
4. Check the dimensions with the table below.

VIN decoding example for Superb 2 2014:

VIN: TMBJD73T4E2123456
Model: Škoda Superb Combi 1.8 TSI (3T5)
Year: 2014 (restyle)
Wipers: 65 cm (left) / 42 cm (right) / 35 cm (rear)

If the decoder does not show the dimensions, use alternative method: Look at the markings on the old brush. Original wipers VAG have an article number like 3T0 955 425 A (left) and 3T0 955 426 A (right), where the last characters indicate the length.

Table of wiper sizes by year and car body

Below are the exact dimensions for all modifications Škoda Superb II (2008–2015). Data confirmed by catalogs ETKA and service manuals VAG.

Year of issue	Body type	Left wiper (driver)	Right wiper	Rear wiper
2008–2012	Liftback / Combi	65 cm	40 cm	35 cm (combi only)
2013–2015	Liftback	65 cm	42 cm	—
2013–2015	Combi (Superb Combi)	65 cm	42 cm	35 cm
2015 (transitional)	Any	65 cm	40 or 42 cm*	35 cm (combi)

*For 2015, the size of the right wiper depends on the month of manufacture. Cars manufactured before mid-2015 are often equipped with 40 cm brushes.

If your car falls into the “borderline” period (for example, late 2012 or early 2013), check the size using the VIN or visually. Alternative - purchase universal brushes with adjustable fastening (for example, Bosch Aerotwin or Valeo Silencio X-TRM), which are suitable for both options.

Why did they change the size of the right wiper on restyled models?

The reason was a change in the angle of the windshield (2° more) and optimization of aerodynamics. The longer blade (42 cm) provides better contact with the glass at high speeds, reducing lift.

Which wipers are better for the Škoda Superb 2: original vs analogues

Original wipers VAG (articles 3T0 955 425 for left and 3T0 955 426 for the right one) cost from 1,500 to 2,500 rubles per set. They are guaranteed to fit in size and fastening, but wear out faster than their premium segment counterparts. Alternatives:

• 💎 Premium class: Bosch Aerotwin (article AR651S and AR420S), Valeo Silencio X-TRM - service life up to 2 years, silent operation, but price ~2,000 rubles. for a couple.
• 🔧 Optimal choice: Denso Hybrid or Trico NeoForm — hybrid design (frame + frameless elements), price ~1,200 rubles, service life 1–1.5 years.
• 💰 Budget option: SWF VisioNext or Champion EasyVision - from 600 rubles, but last 6–8 months.
• ⚠️ Not recommended: cheap frameless brushes (for example, NoName for 300 rubles) - they are poorly cleaned in cold weather and quickly tan.

For Superb Combi It is better to take the original rear wiper (3T0 955 427) or Bosch AR350S — they are optimized for the curved glass of the station wagon. Cheap analogues often leave uncleaned stripes along the edges.

Tip for choosing: if you drive mainly on the highway, give preference aerodynamic brushes (for example, Valeo Silencio). They adhere better to the glass at speeds above 100 km/h. Hybrid models are suitable for the city - they retain the elasticity of rubber longer.

Check the year of manufacture and body type|Check the size of the right wiper (40 or 42 cm)|Select the type of fastening (hook 9x3 or 9x4)|Pay attention to the winter resistance of the tires|Check the article numbers with the catalog (ETKA or Autodoc)-->

Step-by-step replacement of wipers on Škoda Superb 2

Replacing brushes with Superb II takes 5-10 minutes and requires no tools. The main thing is to remove the old wipers correctly so as not to damage the trapezoid. Sequence of actions:

1. Raise the wiper to the vertical position (perpendicular to the glass). To do this, turn on the ignition, activate the windshield wiper for 1 cycle and turn it off at the top point. Do not pull the lever by force!
2. Press the fastening latch (usually a plastic latch on the side or a button on the lever). On original brushes VAG red fastener.
3. Slide the brush down (towards the glass) and remove it from the hook. If it doesn’t give in, rock it a little left and right.
4. Install a new brush, aligning the mount with the hook of the lever. There should be a click.
5. Lower the wiper onto the glass and check operation at minimum speed.

Typical replacement mistakes:

• ❌ Removal force: If you pull the brush upward (away from the glass), you can break the plastic retainer or bend the lever.
• ❌ Mount mismatch: on Superb 2 hook is used 9x3mm or 9x4 mm. Make sure the new brush is compatible (indicated on the packaging).
• ❌ Installation by eye: even if the brush is up, check its operation - it should not cling to the hood seal.

For the rear wiper (on a combi) the process is similar, but the mount can be like top-lock (latch on top). In this case, press the button on the brush and pull it towards you.

Common problems and solutions

Even after correctly replacing the wipers Superb 2 may not work correctly. Let's look at typical faults and how to fix them:

⚠️ Attention: If the wipers move jerkily or stop mid-cycle, the problem may be trapezoidal wiper or a motor. In this case, diagnostics are required (the error code can be read via VCDS or OBDeleven).

• 🔊 Creak during operation:
  • Reason: rubber wear, glass or fastening contamination.
  • Solution: wipe the glass with alcohol, lubricate the lever hinges with silicone grease, replace the brushes.
• 🌧️ Poor cleaning around edges:
  • Reason: incorrect brush size or deformation.
  • Solution: Check the size (especially the right wiper), replace with a hybrid model with better clamping.
• ❄️ Wipers freezing in winter:
  • Reason: ice on glass or rubber, non-winter brushes.
  • Solution: use winter wipers (for example, Bosch Winter) or treat the rubber with silicone lubricant.

If the wipers stick in the down position, check lever springs - they may weaken over time. To test, lift the lever by hand: it should lock in a vertical position without sagging.

For owners Superb 2 with the system Rain Sensor (rain sensor): after replacing the wipers, it may be necessary sensor calibration. To do this:

1. Turn on the ignition.
2. Activate the wipers to interval.
3. Press and hold the windshield wiper lever in position up 5 seconds.

FAQ: answers to frequently asked questions

Is it possible to install wipers longer than the original?

No, this will lead to:

• increased load on the motor (risk of burnout),
• deterioration of aerodynamics (noise at speed),
• scratches on the glass (if the brush clings to the seal).

The exception is brushes with adjustable length (for example, HEYNER Variomatic), but their maximum size should not exceed the original by more than 2 cm.

What is the article number of the original wipers for the Superb Combi 2014?

For Superb Combi 2014 (restyle) original articles:

• Left: 3T0 955 425 B (65 cm),
• Right: 3T0 955 426 B (42 cm),
• Rear: 3T0 955 427 A (35 cm).

The letter at the end of the article (A/B) indicates a revision of the part. The version is current for 2014 B.

What is the difference between wipers for liftback and combo?

Dimensions front wipers are the same for both body types. The only difference is rear wiper:

• Liftback: rear wiper no.
• Combi: rear wiper 35 cm with fastening top-lock.

Can also be installed on the combi washer nozzle for the rear wiper (article no. 3T0 955 987).

How often do you need to change wipers on Superb 2?

Recommended replacement interval:

• Original/premium: every 12–18 months.
• Budget analogues: every 6–12 months.
• Winter brushes: annually (rubber loses elasticity after frost).

Signs of wear: stripes on the glass, creaking, “missing” during operation, cracking of rubber.

Is it possible to restore old wipers?

Partially yes. Methods:

1. Cleaning rubber with alcohol or a special cleaner (for example, Sonax Wiper Blade Cleaner).
2. Glass polishing (removes microcracks, because of which the brushes "jump").
3. Replacement of rubber inserts (for frame wipers, for example, Trico Refill).

However, the recovery has a temporary effect (1-2 months). With severe wear, it is better to replace brushes.