Headlights on the ŠKODA Octavia Tour: how to select, replace and tune without errors

Headlights on ŠKODA Octavia Tour is not just a lighting element, but a key factor in the safety and style of the car. Visibility at night depends on the quality of light, and the overall image of the car depends on the appearance of the headlights. Owners Octavia Tour (especially generations A5 and A7) often encounter problems: cloudy glass, burnt-out lamps, incorrect operation LED modules or the desire to update optics to modern standards.

In this article we will analyze all aspectsassociated with headlights Octavia Tour: from the selection of original and analog spare parts to step-by-step replacement and tuning. We will pay special attention a common mistake when installing LED lamps in halogen headlights, which leads to glare and fines. You will also find current article numbers, price comparisons and tips for setting up the light without visiting a service station.

Original headlights for the ŠKODA Octavia Tour: part numbers and features

Factory headlights Octavia Tour vary depending on generation and configuration. For model A5 (2004–2013) original headlights were produced under article numbers 6U2 941 007/008 (left/right for basic version) and 6U2 941 015/016 - for versions with xenon. In restyled Octavia Tour FL (2009–2013) headlights with article numbers were installed 1Z2 941 007/008 (halogen) and 1Z2 941 015/016 (xenon).

For A7 (2013–2020) and FL versions (2017–2020) original headlights have different designations:

• 🔦 Halogen: 5E2 941 007/008 (base), 5E2 941 009/010 (with DRL)
• 💡 Xenon: 5E2 941 015/016 (bi-xenon), 5E2 941 017/018 (with adaptive light)
• 🔋 LED: 5E2 941 021/022 (only for top RS and Laurin & Klement trim levels)

It is important to consider that headlights for Octavia Tour (station wagon) may differ from the sedan in terms of fastenings and the shape of the lens. For example, in A5 the station wagon has an elongated headlight housing with a different angle, which affects the light adjustment. When purchasing, check the markings on the case - it should contain the letter K (for combi).

⚠️ Attention: Headlights from Octavia A5 the sedan is not physically suitable for Tour due to different body geometry. Attempt to install them may result in misaligned light beams and failure to pass technical inspection.

Generation	Headlight type	Article (left/right)	Approximate price, rubles
A5 (2004–2009)	Halogen	6U2 941 007/008	12 000–18 000
A5 FL (2009–2013)	Xenon	1Z2 941 015/016	25 000–35 000
A7 (2013–2017)	LED (RS)	5E2 941 021/022	45 000–60 000
A7 FL (2017–2020)	Adaptive xenon	5E2 941 017/018	38 000–50 000

What kind of lamps are in the headlights of the ŠKODA Octavia Tour: types and analogues

Type of headlight bulbs Octavia Tour depends on the year of manufacture and configuration. In the majority halogen The following lamps are used:

• 💡 Low/high beam: H7 (55 W) - original article number N 103 200 01
• 💡 Dimensions: W5W (5 W) - article N 017 753 2
• 💡 Turn signals: PY21W (orange) - article N 104 401 01

B xenon headlights are equipped with gas-filled lamps D1S (for A5) or D3S (for A7) with ignition unit. Original xenon lamps from ŠKODA have an article number 4D0 941 001/002, but often owners choose analogues from Osram (66140) or Philips (85122+).

For LED headlights (only A7 RS/Laurin & Klement) the lamps are assembled with the module and cannot be replaced separately. However, if one diode fails, the entire unit has to be replaced, which costs 20 000–30 000 ₽ per side.

When choosing analogues, pay attention to color temperature:

• 🔆 4300K - standard for xenon (maximum luminous efficiency)
• 🔆 5000K - “white” light, close to daylight
• 🔆 6000K+ - “blue” tint, does not penetrate fog worse, but is popular for tuning

⚠️ Attention: Installing LED lamps in halogen headlights Octavia Tour without modification of the reflector leads to incorrect light spot and blinding oncoming drivers. This violates clause 3.6 of the Traffic Regulations of the Russian Federation and is punishable by a fine of 500 rubles (Article 12.5 of the Administrative Code).

Step-by-step replacement of headlights on a ŠKODA Octavia Tour: instructions with photos

Replacing the headlight with Octavia Tour requires caution, especially when working with xenon or LED modules. Let's look at the process using an example A7 (for A5 the algorithm is similar, but the fastenings are different).

Required tools:

• 🔧 10 mm socket wrench
• 🔧 T20/T25 screwdriver
• 🔧 Plastic spatulas for removing clips
• 🔧 Gloves (to avoid leaving fingerprints on the glass)

Procedure:

1. Disconnect the negative terminal of the battery (required!).
2. Remove the front bumper (unscrew the 4 bolts from the bottom and 2 clips from the sides).
3. Disconnect the headlight power connector (press the lock and pull down).
4. Unscrew the 3 headlight mounting bolts: two from above (under the hood) and one from below (on the bumper side).
5. Carefully pull out the headlight without pulling on the wires.

Disconnected the battery

Removed the bumper (or provided access to the mounts)

Prepared a new headlight (checked the article number)

I have tools on hand (T20, wrench 10)

I don’t touch the headlight glass with my bare hands -->

When installing a new headlight necessarily check:

• 🔌 The connector is connected correctly (the contacts should not be oxidized).
• 🔧 Tighten the bolts (misalignment will lead to incorrect adjustment).
• 💧 The housing is sealed (if moisture gets in, the headlight will have to be disassembled).

What to do if the headlight is jammed?

If the headlight cannot be pulled out of its seat, do not force it - check:

1. Are all the bolts unscrewed (sometimes they forget the bottom bolt under the bumper).

2. Does the headlight cling to the radiator or pipes?

3. Is there any corrosion on the guides (treat with WD-40).

As a last resort, carefully pry the headlight from the side of the fender with a plastic spatula.

Adjusting headlights on Octavia Tour: how to do it right

Incorrect headlight adjustment Octavia Tour leads to dazzling of oncoming drivers or insufficient illumination of the road. According to the Russian Federation Traffic Regulations (clause 3.3), the light beam must be adjusted so that the upper limit is at the level 1% height of headlight from ground (for example, for a headlight at a height of 60 cm - 6 mm below the center of the mark on the screen).

To adjust you will need:

• 📏 Flat area (no slope).
• 📏 Vertical wall or screen at a distance of 5–10 m.
• 📏 Screwdriver for adjustment screws (located on the back of the headlight).
• 📏 Load 70–80 kg on the driver's seat (or passenger).

Step-by-step algorithm:

1. Place the car at a distance of 5 m from the wall. Check tire pressure and even loading.
2. Draw vertical lines on the wall corresponding to the centers of the headlights and a horizontal line 5 cm below the height of the headlights.
3. Turn on the low beam. The upper boundary of the light spot should coincide with the horizontal line.
4. Adjust the vertical and horizontal adjustment screws (on Octavia Tour they are marked as H and V).

For xenon and LED headlights adjustment is carried out automatically by the system AFS (Adaptive Front-lighting System). If the light "floats", it may be faulty body level sensor (located on the rear suspension arm) or control unit J745. Diagnosis can be made through VCDS (error code 02556 indicates a problem with the sensor).

Headlight tuning for Octavia Tour: LED, angel eyes, tinting

Headlight tuning Octavia Tour improves the appearance and functionality of the optics. Popular destinations:

• 🔦 Installation LED lamps in halogen headlights (needs improvement).
• 👼 Installation "angel eyes" (CCFL or LED strips).
• 🖤 Tinting headlight glasses with film or varnish.
• 🔧 Replacing the diffuser with "blink" (demon eye effect).

LED tuning - the most popular, but also the most difficult. For Octavia Tour A5/A7 suitable kits:

• 💡 Morimoto 2Stroke 2.0 — the best option for halogen headlights (price ~15,000 rubles).
• 💡 Osram LEDriving HL — a budget analogue (~8,000 rubles), but requires the installation of anti-glare caps.
• 💡 Philips X-tremeUltinon — premium option with a guarantee (~20,000 rubles).

To legally install LEDs in halogen headlights you must:

1. Install lenses with a clear cut-off line (for example, Morimoto Mini H1 7.0).
2. Modify the headlight housing (sealing, heat dissipation).
3. Pass recertification to the State Traffic Safety Inspectorate (a preliminary examination report is required).

⚠️ Attention: Tinting headlights with film or varnish reduces light transmission by 20–30%, which worsens the illumination of the road and can cause an accident. According to GOST R 51709-2001, the light transmission of headlights must be at least 70%.

Common problems with Octavia Tour headlights and their solutions

Owners Octavia Tour often encounter typical headlight malfunctions. Let's look at the most common ones:

Problem	Reason	Solution
Headlight fogging	Violation of tightness (crack in glass or seal)	Dry the headlight with a hairdryer, seal the cracks with sealant ABRO ES-350
Xenon flicker	Malfunction of the ignition unit or lamp	Replace block (4D0 941 329) or lamp (D1S/D3S)
Error "Low beam" on the panel	The lamp has burned out or the contacts have oxidized	Check the lamp H7 and clean the connector T10
The light "hits" upward	The adjustment has gone wrong or the springs have sagged	Adjust the headlight or replace the suspension springs

If an error light appears on the dashboard "Check front left/right headlamp", check:

• 🔌 Fuse status SC5 (10A) and SC6 (10A) in the block under the steering wheel.
• 🔌 Integrity of wiring from the control unit J667 (for A7) or J519 (for A5).
• 🔌 Light sensor performance (G397) located on the windshield.

To reset the error after replacing lamps or headlights, use a diagnostic scanner (VCDS, OBDeleven) or perform a reset via the on-board computer menu:

1. Press and hold the button SET/RESET on the steering column switch.
2. Turn on the ignition (without starting the engine).
3. Hold the button for 10 seconds until the message appears "Service reset".

FAQ: Frequently asked questions about headlights on the ŠKODA Octavia Tour

Is it possible to install LED lamps in halogen headlights without modifications?

No, this violates traffic rules and creates a danger for other drivers. LED lamps in halogen headlights produce an incorrect light spot due to different focusing. For legal installation, you need to replace the reflector with a lensed one or purchase headlights with factory LED (only for A7 RS/Laurin & Klement).

What is the part number for the original left headlight for Octavia Tour A7 FL with xenon?

For Octavia Tour A7 FL (2017–2020) with bi-xenon left headlight article number - 5E2 941 015 A, right - 5E2 941 016 A. Pay attention to the letter A - she points to the restyled version.

Why do H7 lamps burn out quickly after replacement?

Common reasons:

• 🔌 Poor contact in the connector (oxidation or burning).
• 🔌 Increased voltage in the on-board network (check the generator).
• 🔌 Using cheap lamps with a thin filament.

We recommend installing voltage stabilizer for headlights or use lamps with a reinforced spiral (for example, Osram Night Breaker Laser).

How to remove the headlight on an Octavia Tour A5 without removing the bumper?

On Octavia Tour A5 You can remove the headlight without removing the bumper completely, but you will need:

1. Unscrew the 2 bolts securing the bumper to the fender.
2. Bend the bumper to the side (no more than 10 cm).
3. Unscrew the lower bolt of the headlight through the technological hole.

However, this is risky - there is a high chance of damaging the bumper clips.

Which headlights from other ŠKODA models are suitable for the Octavia Tour?

Headlights from ŠKODA Superb II (2008–2015) suitable for Octavia Tour A5 on fastenings, but have a different diffuser shape and require modifications to the bumper. Headlights from Octavia A7 sedan not compatible with Tour due to different body lengths. The only 100% compatible option is headlights from Octavia Scout (for A5/A7), but they are 20–30% more expensive.