Rear wiper on Škoda Fabia II - a part that often fails due to intensive use or natural wear. Unlike the front wipers, the rear mechanism has a unique mounting design, and its replacement requires care. Many owners Fabia are faced with a problem: how to remove the rear wiper without damaging the glass or plastic elements of the body?

In this article we will analyze the dismantling process step by step - from preparing tools to installing a new wiper. We will pay special attention typical mistakes, which lead to damage to the latch or electric motor. You will also learn how the mechanisms on a hatchback and station wagon differ Fabia Combi, and what to do if the wiper is “jammed” in the extreme position.

The instructions are suitable for all modifications Škoda Fabia II (2007–2014), including restyled versions. If you've never had to repair a car, don't worry - the process is easier than it seems if you know key nuance: the wiper lock is held not by a bolt, but by a plastic latch.

Preparing for dismantling: tools and safety precautions

Before you begin removing the rear wiper, prepare your work area and tools. You will need:

  • 🔧 Flathead screwdriver (preferably with a thin blade)
  • 🔨 Plastic puller or mediator (for gentle dismantling)
  • 🧤 Clean cotton gloves (to avoid leaving marks on the glass)
  • 📦 New wiper (if you plan to replace) - check compatibility according to article number 6R0 955 425 for original part

Work in dry weather or in a garage - moisture on the glass will complicate the process. If the wiper is stuck, you may need to penetrating lubricant (eg WD-40), but use it carefully so as not to damage the rubber seals.

⚠️ Attention: Never pull the wiper up with force - this may break the plastic hinge. The latch opens by pressing the latch, not twisting it!

If you are replacing a wiper because the motor is faulty (for example, it does not return to its original position), check the fuse before removing it F36 (10A) in the block under the steering wheel. Sometimes the problem lies in the electrical circuit, and not in the mechanics.

📊 How often do you change the rear wiper on your car?
  • Once a year
  • Every 2 years
  • Only in case of breakdown
  • Never changed

Step 1: Removing the Plastic Wiper Cover

On Škoda Fabia II The rear wiper is attached through a plastic cover that covers the mechanism. To remove it:

  1. Pry it off with a screwdriver or plastic puller bottom edge of the lining (from the glass side).
  2. Gently pull the cover towards you - it is held in place by two latches.
  3. If the trim does not budge, check to see if it is caught on the glass seal.

On a station wagon Fabia Combi The cover may have an additional lock on top - lift it on both sides at the same time. Do not use excessive force: plastic becomes brittle in the cold.

Make sure the wiper is in the down position|

Turn off the ignition (to prevent accidental engine start-up)|

Wear gloves to avoid scratching the glass|

Prepare a container for small parts (screws, latches) -->

After removing the cover, you will see a metal wiper hinge and a plastic retainer. At this stage don't try to pull the wiper straight away - First you need to unlock the mount.

Step 2: Unlocking the wiper lock

The key point of the entire process is the correct disconnection of the wiper from the hinge. On Fabia II system is used "push-button", where the latch opens by pressing a special button.

Algorithm of actions:

  1. Click on black plastic button on the side of the hinge (it is located at an angle of ~45° to the glass).
  2. While holding the button, pull the wiper up and on yourself - it should come off easily.
  3. If the wiper does not come off, check whether the button is fully recessed (sometimes you need to press harder).

On restyled versions Fabia (after 2010) the button may be red - this is normal. The main thing is not to confuse it with the lining retainer.

⚠️ Attention: If the wiper is stuck in the up position and the button cannot be pressed, do not use force. First, remove the motor cover (see section 5) and check if any debris has gotten under the mechanism.

After removing the wiper, inspect the hinge for corrosion or wear. If there is rust on it, clean it off. wire brush and apply lubricant (eg LIQUI MOLY LM47).

What to do if the release button is broken?

If the plastic button breaks off, you will have to remove the entire wiper mechanism through the trunk. To do this:

1. Remove the rear door trim (on a station wagon) or the trunk lid (on a hatchback).

2. Unscrew the 3 motor mounting bolts (Torx T20).

3. Remove the mechanism and replace the lock (part no. 6R0 955 427).

It is better to entrust this procedure to a service, as disassembly of the interior is required.

Step 3: Diagnose problems before installing a new wiper

Before installing a new wiper, check that the system is working properly. Frequent problems on Fabia II:

Symptom Possible reason Solution
The wiper doesn't move at all Fuse blown F36 or the motor burned out Check the fuse, replace the motor if necessary (6R0 955 069)
The wiper moves jerkily Worn gears of the gearbox or corrosion of the hinge Lubricate the mechanism; if there is severe wear, replace the gearbox
The wiper does not return to its original position The limit switch is faulty or the wire is broken Test the circuit with a multimeter, replace the limit switch (6R0 955 428)
Grinding noise during operation Debris trapped under the pad or rubber blade worn Clean the mechanism, replace the wiper blade

If you find a faulty motor or gearbox, it is better to replace them immediately so as not to disassemble the system again. Original spare parts for Fabia II They last longer than analogues, but are more expensive (for example, a motor will cost ~3,500 rubles).

💡

Before purchasing a new wiper, check its length: for Fabia II hatchback standard - 300 mm, for station wagon Combi - 350 mm. Installing an incorrectly sized wiper will result in poor glass cleaning or overloading of the motor.

Step 4: Installing a New Wiper

The installation process is the reverse of removal, but there are several nuances:

  1. Place the new wiper on the hinge so that the groove on the brush coincides with the protrusion on the latch.
  2. Press until it clicks - you should hear a characteristic clicking sound.
  3. Pull the wiper down to make sure it is securely in place.

After installation, check the operation of the wiper in several modes:

  • 🔄 Intermittent mode (first switch position)
  • 🌧️ Permanent job (second position)
  • 💦 Washer + wiper (press the lever under the steering wheel)

If the wiper "bounces" or leaves streaks, check:

  • 🔹 Brush tightness to the glass (adjust the mounting angle if necessary)
  • 🔹 Glass cleanliness (fat or wax interferes with normal operation)
  • 🔹 Rubber Blade Condition (new wipers sometimes have a protective film - remove it)
⚠️ Attention: After replacing the wiper, do not turn on the washer for the first 10 minutes - let the rubber adapt to the glass. Otherwise, water may seep under the pad and cause corrosion.
💡

If the new wiper is noisy, most likely the problem is not with it, but with a worn hinge bearing. In this case, the entire fastening mechanism must be replaced.

Step 5: Removing the wiper motor (if necessary)

If the problem lies in the electric motor or gearbox, you will have to remove the entire mechanism. This is a more complex procedure that requires disassembling the casing. For Škoda Fabia II the algorithm is like this:

  1. Remove the wiper cover (as in step 1).
  2. Unscrew the 3 motor mounting bolts (Torx T20).
  3. Disconnect the electrical connector (it is secured with a plastic latch - pry it off with a screwdriver).
  4. Remove the mechanism through the technological hole in the body.

On a station wagon Fabia Combi access to the motor is complicated - you will have to remove part of the trunk trim. If you are not confident in your abilities, it is better to contact the service: the cost of replacing the motor is ~1,500–2,000 rubles.

When installing a new motor (article number 6R0 955 069) don't forget:

  • 🔧 Connect the connector before fixing the bolts (otherwise it’s inconvenient)
  • 🔄 Check the operation of the wiper before assembling the casing
  • 🧴 Apply dielectric grease to the connector contacts

Common mistakes and how to avoid them

Even experienced car owners sometimes make mistakes when working with the rear wiper. Fabia II. Here are the most common:

  1. Using metal tools to remove the trim → scratches on glass or plastic. Always use a plastic puller.
  2. Using force when the latch is jammed → broken button or hinge. First, clean the mechanism from dirt.
  3. Installing a Wiper of the Wrong Length → motor overload or poor cleaning. For Fabia hatchback only 300 mm!
  4. Ignoring fuse check → replacing a working wiper if the electrical circuit is faulty.

Another typical problem is water getting into the mechanism after high pressure washing. To avoid this, cover the wiper cover with tape or use special covers before washing.

If the wiper is unstable after replacement, check:

  • 🔌 Quality of contacts in the motor connector (oxidation is a common cause of failures)
  • 🔧 Tightening the mounting bolts (too loose fixation leads to vibrations)
  • 📶 On-board voltage (during subsidence, the wiper may slow down)
💡

On Fabia II with climate control Climatronic The rear wiper may turn on automatically when the defrost function is activated. This is normal behavior and not a malfunction!

FAQ: Answers to frequently asked questions

Is it possible to remove the rear wiper Fabia II without tools?

Theoretically, yes, if the fixative is not stuck. To do this, you need to press the button firmly and pull the wiper up. However, without a screwdriver or puller, it is difficult to remove the plastic cover without damaging it. There is no need to take risks - the tools are inexpensive.

How often should the rear wiper be replaced?

The recommended interval is once every 1–2 years, but it all depends on the intensity of use. Signs of wear: stains on the glass, creaking during operation, incomplete water purification. On Fabia With a heated rear window, the wiper rubber wears out faster due to temperature changes.

What should I do if my wiper leaves streaks after replacing it?

Wash the glass first degreaser (for example, Sonax Glass Cleaner). If streaks remain, check to see if the brush is skewed. New wipers sometimes have rubber defects - in this case, replace the part under warranty.

Is it possible to install a frameless wiper on Fabia II?

Yes, but only if it is certified for that model. Frameless wipers (for example, Bosch Aerotwin) are lighter and fit better to the glass, but their fastening must coincide with the original one. Please check VIN compatibility before purchasing.

Why is the rear wiper on Fabia Combi is it slower than the hatchback?

This is due to the length of the brush: on the station wagon it is longer (350 mm versus 300 mm), so the motor experiences more load. If the wiper is stuck, check the voltage at the motor terminals - it should be at least 11.5 V when the engine is running.