Owners ล KODA Octavia A7 (2013-2020) sooner or later face the need to replace lamps - whether it is a burnt out passing headlight, a dull size or a failed light bulb in the cabin. But how to understand the variety of types of caps, capacities and manufacturers? This article will not only help to determine the What are the lamps in your Octavia A7?But also to choose high-quality analogues, avoid errors when replacing and save on service.
We analyzed the technical documentation ล KODAOwnersโ reviews and recommendations of automotive electrical systems to collect up-to-date information on all types of lamps โ from headlight to glove compartment lighting. Special attention was paid to nuances for restyled versions (2017+)where the manufacturer has made changes to the optics. You will also find step-by-step instructions, warnings about typical errors, and tips for choosing between halogen, LED, and xenon (where permitted by law).
Types of lamps in the front optics of the Octavia A7: near, long and dimensions
Front optics Octavia A7 It is a complex system where each light bulb is responsible for its own lighting zone. In the basic versions (before facelift 2017) were used halogen lampsAnd in the top-end configurations, xenon (Bixenone) or LEDs. Let's see where it stands:
- ๐ก Low beam: base
H7(halogen 55 W) orD1S(Xenon 35 W) - depends on the configuration. In the restyled versions (2017+) is possible factory LED optics. - ๐ฆ High beam: base
H1(55 W) in halogen headlamps. In xenon systems, long-range is implemented through bixenon lampsD1Swith a movable screen. - ๐ก Side lights: base
W5W5W is the standard for all versions. In LED optics, non-collectible modules are used. - ๐ Turn signals: base
PY21W(21 W) - orange lamp with a single-stranded spiral.
Important: in Octavia A7 with full LED optics (optional LED Matrix After 2018, there are no incandescent lamps - there are indissoluble modules that change completely. Attempt to install LED lamps in halogen headlights will cause an error on the dashboard and possible failure of the light control unit (BCM).
- Halogen (H7/H1)
- Xenon (D1S)
- Light Emitting Diodes (LED)
- I don't know
| Lamp type | Base | Power | Notes |
|---|---|---|---|
| Low beam (halogen) | H7 |
55 W | Standard for basic versions. Analogues: Osram Night Breaker, Philips X-tremeVision |
| Near/far (bixenon) | D1S |
35 W | Requires a block of ignition. Only a couple! |
| High beam (halogen) | H1 |
55 W | In xenon headlights is absent - the function is performed by bixenon |
| Dimensions | W5W |
5 W | Can be replaced with LED T10 without errors (if no canbus) |
โ ๏ธ Note: Replacement of xenon lamps D1S Never touch the bulb with your fingers - fatty traces lead to local overheating and explosion of the lamp. Use gloves or a napkin!
Rear lights: stop lights, reverse and turn signals
Rear optics Octavia A7 unified for all bodies (liftback, station wagon Combi). Lamps with sockets are used here P21W, PY21W and W16W, but there are nuances:
- ๐ Brake lights: base
P21W(21 watts). In the versions with LED optics (after 2017) the lamps are missing โ the module changes completely. - ๐ Reverse: base
P21W(white color). It often burns out due to moisture entering the ceiling. - ๐ก Turn signals: base
PY21W(orange). In LED versions, there is an indissoluble block. - ๐ด Dimensions/licence lighting: base
W5W(same as front dimensions).
Deserves special attention condensation in the taillights. If the lamps often burn out or moisture accumulates inside the plafond, check:
- Integrity of sealing rubber band on the lid of the lamp.
- No cracks in the body (especially after an accident).
- The operation of the ventilation valve (a small hole in the lower part of the lamp).
Before replacing the lamp in the rear light, turn off the battery's minus terminal - this will save you from short circuits when accidentally touching contacts.
In the restyled versions (2017+), the rear optics can be fully LED. In this case, when the individual segments fail, the entire module is required to be replaced (the item depends on the body: 5E2 945 097/098 for liftback, 5E5 945 097/098 for Combi). The cost of the original module is from 15 000 rubles per side.
Lamps in the cabin and trunk: from the ceiling to the lighting of the glove compartment
Salon Octavia A7 It has a lot of lights, and it has its own features. Most lamps have a base. W5W or C5WBut replacing them requires care โ especially in shades with touch switches.
| Installation location | Base | Power | Notes |
|---|---|---|---|
| Interior lighting (front) | C5W |
5 W | Two lamps. Can be replaced by LED Festoon 31mm |
| Truck platon | W5W |
5 W | B Combi Two lamps, one in the elevator. |
| Glove compartment lighting | W5W |
5 W | The lamp is inserted into the cartridge with a rotation of 90ยฐ |
| Foot lights (front) | W1.2W |
1.2 W. | Miniature lamp, often burns out during wet cleaning |
When replacing lamps in the cabin, consider:
- ๐ง To access the lamp lighting cabin will require a flat screwdriver - carefully tuck the body around the perimeter.
- ๐ก In the glove compartment, the lamp is fixed by turning the cartridge. Donโt make an effort โ plastic latches are fragile!
- โก When installing an LED lamp, check the polarity โ the wrong connection leads to flickering.
How to remove the interior lamp?
1. Then, put the right hand on the right side of the slap. 2. Disconnect the power connector by pressing the lock. 3. Replace the lamps by observing polarity for LEDs. 4. Place the plafond in place before the click.
โ ๏ธ Attention: In versions with Ambient Lighting (optional interior lighting) LED tapes are used, which are not subject to partial replacement. When individual segments fail, the entire module (article) must be replaced. 5E0 947 131).
How to choose lamps: halogen vs LED vs xenon
When replacing lamps in Octavia A7 The question for the owner is: which lamps to choose? Letโs look at the pros and cons of each type:
Halogen lamps
Pros:
- โ
Low price (from 200 rubles for a lamp)
H7). - โ Easy to replace โ does not require modifications.
- โ Compliance with the law (do not need to be coordinated with the traffic police).
Cons:
- โ Service life - 500โ1000 hours.
- โ Dim light compared to LED/xenon.
- โ Sensitivity to stress surges.
Light Emitting Diodes (LED)
Pros:
- โ Brightness up to 6000 Lm (3 times brighter than halogen).
- โ Service life - up to 30,000 hours.
- โ Low energy consumption (lower load on the generator).
Cons:
- โ Price - from 3000 rubles per set
H7. - โ Risk of errors on the dashboard (requires lamps with a decoy CAN-bus).
- โ Not all LED lamps are certified for use on public roads.
Xenon lamps
Pros:
- โ Maximum brightness and range of light.
- โ The service life is up to 2,000 hours.
Cons:
- โ High price (from 5000 rubles per set)
D1S+ ignition units. - โ Prohibited self-assembly in halogen headlights (fine 3000 rubles per article). 12.5 CAO).
- โ Moisture sensitivity โ ignition blocks often fail.
Installation of xenon in halogen headlights is not only illegal, but also dangerous - improper focusing leads to the blinding of oncoming drivers.
For Octavia A7 With halogen optics, the best choice will be improved halogen lamps (for example, Osram Night Breaker Laser or Philips RacingVision). They give 150 percent more light than standard ones and are completely legal. If you have a factory. LED opticsThere is no replacement of the lamps, only the modules.
Step by step instructions for replacing lamps in the Octavia A7
Replacing lamps in Octavia A7 It does not require special skills, but it is important to follow the instructions so as not to damage plastic elements or wiring. Let's look at the process by example. low beam lamps H7:
- Preparation: turn off the engine, turn on the parking brake and turn off the battery's negative terminal (key 10 mm).
- Access to headlightOpen the hood and remove the protective rubber cover from the back of the headlight (pull the tongue).
- Disconnecting the connectorPress the power pad locker and carefully remove it from the lamp.
- Removing the lamp: press the spring-loaded fixator (metal bracket), take it aside and remove the lamp.
- Installing a new lampPut the lamp in the cartridge (without touching the bulb!), fix the brace and connect the connector.
- CheckTurn on the passing light and make sure the lamp is working without flickering.
Make sure the lamp burns evenly, without darkened areas | Check the tightness of the rubber headlamp cover | Clear the contacts of the connector from oxidation (if necessary) | Reset an error on the dashboard (if it appears)->
To replace lamps in the rear lights, the algorithm is different:
- Open the trunk and remove the skin from the side of the lamp (click the pistons).
- Unscrew two plastic screws of the mounting of the flashlight (cross screwdriver).
- Carefully pull the light on yourself, do not pull the wires!
- Turn the socket counterclockwise and remove the lamp.
- Install a new lamp, observing the cap, and collect everything in reverse order.
โ ๏ธ Note: When replacing lamps in the taillights, do not use metal screwdrivers to remove the pistons of the skin - this will damage the plastic. Better use a plastic sedan or wrap the screwdriver with tape.
Common mistakes and how to avoid them
Even experienced car owners make mistakes when replacing bulbs. Octavia A7. Here are the most common ones and how to prevent them:
- ๐ง Touching the halogen lamp bulb: Fat from the fingers leads to local overheating and shortens the service life. Always use gloves or wipe the flask with alcohol.
- โก Wrong polarity of LED lampsIf the lamp does not burn or flicker after installation, turn it in the cartridge 180ยฐ.
- ๐ Forgetting to reset the error: After the lamp is replaced (especially in xenon headlamps), an error may burn on the dashboard. Drop it through the menu.
Settings โ Service โ Reset errorsOr a diagnostic scanner. - ๐ก Buying cheap analoguesLamps of unknown brands often have inappropriate color temperature (for example, 8000K instead of the standard 4300K), which blinds oncoming drivers.
- ๐ Ignoring contacts: oxidized or contaminated contacts in the cartridge lead to flickering of the lamps. Clean them with a small sandpaper or a special spray.
Pay special attention Problem with the light control unit (BCM). B Octavia A7 It is sensitive to voltage surges that can occur when replacing lamps. If after installing a new lamp, several lights stopped working at the same time, check the fuses. F37 (10A) and F42 (15A) in the mounting block under the steering wheel.
How to check the light control unit (BCM)?
1. Connect a diagnostic scanner (for example, VCDS or OBDeleven).
2. Go to the block 09 โ Cent. Elect..
3. Check for errors at the address Light Switch (E1) or Headlight Range Control (J431).
4. If there are errors in the lamp chain, check the wiring with a multimeter.
FAQ: Frequent questions about the lamps in the Octavia A7
Can I put LED lamps in the halogen headlights of the Octavia A7?
Technically yes, but with caveats:
- ๐น Lamps must be certified according to GOST R 41.99-99 (sign
E22orE1on the packaging). - ๐น Presence required swindleOtherwise, there will be a bug on the panel.
- ๐น The light beam should correspond to halogen optics - many LED lamps blind oncoming drivers.
It is legal to use LED lamps in halogen headlights it's impossible - this is equivalent to a change in the design of the vehicle (a fine of 500 rubles per article). 12.5 CAO).
Which lamp company is better to choose for the Octavia A7?
Recommended brands (price/quality ratio):
- ๐ฅ Osram (series Night Breaker, Cool Blue) is the best choice for the halogen.
- ๐ฅ Philips (series X-tremeVision, LongLife EcoVision) - long service life.
- ๐ฅ Bosch (series Pure Light) โ budget option with good characteristics.
- ๐ MTF Light (for LED) โ one of the few legal LED lamps with a certificate
ECE.
Avoid Chinese no-name brands โ their lamps often have overrated power and fail quickly.
Why do lamps burn out quickly in Octavia A7?
Main reasons:
- Overvoltage in the on-board network (more than 14.5 V). Check the generator voltage regulator.
- Vibrations This is especially true for lamps in the rear lights. Use a lamp with a reinforced spiral (for example, Philips LongLife).
- Moisture ingress (c) a headlight or a flashlight, which leads to corrosion of the contacts.
- Frequent on/off Light (for example, when driving in a city) reduces the life of lamps.
If the lamps are burning for less than 3 months, check them. relay (J329) In the mounting unit, it may be faulty.
How to Reset the Lamp Error on the Dashboard?
Reset methods:
- ๐ง Via the on-board computer menu:
Settings โ Service โ Reset errors. - ๐ Turn off the battery terminal for 10 minutes (reset all errors, including non-critical ones).
- ๐ฑ Using a diagnostic adapter (ELM327, VCDS) and programmes OBDeleven or Carista.
If the error appears again, check:
- Integrity of lamp and contacts in the cartridge.
- Presence of moisture in the headlamp/lamp.
- Fuse status
F37andF42.
Can I use the Octavia A7 headlight?
Yes, but with caution:
- Use abrasive paste with a grain content of 1000โ3000 (for example, 3M Headlight Restoration Kit).
- After polishing, be sure to apply protective varnish (for example, Delta Kits Clear Coat), otherwise the headlamp will quickly become cloudy again.
- Do not polish the headlight "dry" - this will lead to microcracks.
If the headlight has strong chips or cracks, polishing will not help - you will need to replace the glass or the entire headlight.