Audio system in Škoda Octavia Tour - one of the key elements of comfort, especially for those who spend a lot of time behind the wheel. However, standard speakers often do not satisfy music lovers: wheezing at high frequencies, weak bass or distortion during loud music become reasons for an upgrade. But before buying new speakers you need to know them exactly dimensions, mounting type and electrical parametersto avoid installation problems.

In this article we will look at exact speaker dimensions for all generations of Octavia Tour (A5, A7, restyled versions), including front, rear and tweeters. You will also learn which non-standard models are suitable for replacement without modifications, how to check compatibility with the radio, and what mistakes are most often made during installation. If you are planning to improve the sound in your car, this guide will help save time and money.

Standard speakers in the Škoda Octavia Tour: models and generations

Audio systems in Octavia Tour vary depending on generation and configuration. Let's look at the key features:

  • 🔹 Octavia A5 (2004–2013) - basic audio system Swing or Bolero with 6–8 speakers. In top versions, a subwoofer was installed in the trunk.
  • 🔹 Octavia A7 (2013–2020) — improved acoustics, including optional Canton Sound System with 10 speakers and amplifier.
  • 🔹 Restyled versions (FL) - often equipped with speakers with modified connectors, which complicates replacement.

It is important to consider that even within the same generation, speaker sizes may vary. For example, in Octavia A5 with the system Bolero the front full-range speakers have a diameter 165 mm, whereas in the basic configuration - 130 mm. Therefore, before purchasing new speakers be sure to check the VIN or physically measure the standard ones.

📊 What audio system does your Octavia Tour have?
  • Swing/Bolero (basic)
  • Canton (premium)
  • Other (specify in comments)
  • I don't know

Front speaker sizes: compatibility chart

Front speakers in Octavia Tour are responsible for the main sound image, so replacing them gives the greatest effect. Below is a table with sizes for different generations:

Generation Speaker type Diameter (mm) Depth (mm) Notes
Octavia A5 (2004–2013) Broadband 130 or 165 45–50 Included Bolero — 165 mm
Octavia A7 (2013–2020) Coaxial 165 50–55 Compatible with Canton when replacing connectors
Octavia A7 FL (2017–2020) Component 165 (midbass) + tweeter 55–60 Requires adapter rings for non-standard models

To replace the front speakers in Octavia A5/A7 often choose models from Focal, Alpine or Hertz. For example, Focal ISU 165 (165 mm) fits without modifications, but requires an adapter for the connector. B A7 FL with a component system, you will have to buy additional crossovers and lay new wires to the tweeters.

⚠️ Attention: B Octavia A7 with the system Canton The speakers have non-standard connectors. When replacing with non-standard speakers, you will need to cut off the standard connectors and solder new ones or use adapters.

Rear speakers: installation features

Rear speakers in Octavia Tour usually smaller than the front ones and are responsible for filling the cabin with sound. Their sizes:

  • 🔊 Octavia A5: diameter 130 mm, depth 40 mm (in the door or on the shelf).
  • 🔊 Octavia A7: diameter 165 mm (at the door) or 100 mm (on the back shelf).
  • 🔊 Restyled versions: Oval speakers are often used 6x9 inches (150x230 mm) on the rear shelf.

When replacing the rear speakers in Octavia A7 It is important to consider that the space in the doors is limited - the depth of the new column should not exceed 50 mm, otherwise it will rest against the glass. For oval speakers on a shelf, models from Pioneer or JBL, but you will need to cut new holes or use transition frames.

💡

Before purchasing rear speakers, check whether there is free space behind the door trim. In some configurations, there are wires for electric window drives, which may interfere with the installation of deep speakers.

Tweeters and subwoofer: connection nuances

In top trim levels Octavia Tour (for example, with a system Canton) separate tweeters and a subwoofer are installed. Their parameters:

  • 🎵 Twitters: diameter 25–30 mm, mounted in the upper corners of doors or on racks.
  • 🎵 Subwoofer: in Octavia A58" (200 mm), in A710" (250 mm), placed in the trunk.

When upgrading tweeters, it is important to take them into account sensitivity (dB) and resistance (Ohm). For example, if standard tweeters have resistance 4 ohm, and new ones - 2 ohm, this may cause the amplifier to overload. For subwoofer in Octavia A7 often choose models from JL Audio or Kicker, but you will need to modify the case or install it in a separate box.

How to check the polarity of tweets?

If the tweeters are connected incorrectly, the sound becomes “dull” or the high frequencies disappear. To check the polarity, connect the tweeter to a 9V battery: if the diffuser moves out, the polarity is correct. Otherwise, swap the "+" and "-" terminals.

How to remove and install speakers: step-by-step instructions

Replacing speakers in Octavia Tour requires care, especially if you are doing this for the first time. Basic steps:

  1. Disconnect the negative terminal of the battery to avoid short circuit.
  2. Remove the door card (you will need a plastic spatula and a screwdriver T20/T25).
  3. Disconnect the speaker connector and unscrew the mounting bolts (usually 3–4 pieces).
  4. Install the new speaker, connect the wires (use adapters if necessary).
  5. Check the sound before final assembly.

Disconnect battery

Prepare tools (screwdrivers, spatula, multimeter)

Buy adapter rings (if needed)

Check connector compatibility

Take a photo of the standard wiring

-->

B Octavia A7 with the system Canton may be required flashing the radioso that it recognizes the new speakers. Without this, errors may appear on the screen or the sound may turn off. To flash the firmware, contact the service or use the software VCDS (VAG-COM).

⚠️ Attention: When installing speakers with a power higher than standard (for example, 100W instead of 30W) make sure that the amplifier or radio can support this load. Otherwise, the equipment may be damaged.

Best Speakers to Upgrade: Expert Recommendations

The choice of speakers depends on your budget and audio requirements. Here are proven options for Octavia Tour:

  • 💰 Budget option: Pioneer TS-A1670F (165 mm, 300W) - good price/quality ratio.
  • 🎶 Middle segment: Focal Performance PS 165 (165 mm, component system) - clear sound without distortion.
  • 🏆 Premium: Hertz Dieci DSK 165.3 (165 mm, 3-way system) - for real audiophiles.

For subwoofer in Octavia A7 often chosen JL Audio 10W3v3-4 (250 mm, 500W) - it fits perfectly into its standard place in the trunk. However, to connect it you will need an external amplifier, since the standard radio does not produce enough power.

💡

When choosing speakers, pay attention not only to power, but also to sensitivity (dB). The higher this parameter, the louder the sound will be for the same amplifier power.

Common mistakes when replacing speakers and how to avoid them

Even experienced car owners make mistakes when upgrading their audio system. Here are the most common:

  • 🔧 Incorrect sizing: the speaker does not fit into the seat or rests against the door mechanisms.
  • 🔌 Ignoring polarity: leads to sound imbalance and loss of quality.
  • 🔊 Lack of sound insulation: Without it, the new speakers will sound worse than the standard ones due to body vibrations.

To avoid problems, always test your speakers before installation — connect them temporarily to the radio and evaluate the sound. It is also recommended to use soundproofing materials (for example, Splen or Bitoplast) on the inside of the door card. This will improve bass and reduce background noise.

Is it possible to install 165 mm speakers instead of the standard 130 mm in the Octavia A5?

Yes, but you will need to widen the hole in the door panel or use adapter rings. Also make sure that the depth of the new speaker does not exceed 50mm.

Do I need to change the radio when replacing the speakers?

Not necessarily, but if the new acoustics are more powerful than the standard ones (for example, 100W instead of 30W), the radio may not be able to cope with the load. In this case, an external amplifier will be required.

How to check if a speaker has the right impedance?

Use a multimeter: measure the resistance of the stock speaker (usually 4 ohms) and compare with the new one. If the difference is greater than 20%, the amplifier may need to be replaced.

Is it possible to connect a subwoofer to the standard Octavia A7 radio?

Yes, but only through line-out converter (LOC), since the stock radio does not have RCA outputs. An alternative is to replace the radio with a model that supports a subwoofer.

Which speakers are better for the Octavia Tour: component or coaxial?

Component systems (with separate tweeters and crossovers) provide better sound quality, but are more difficult to install. Coaxial ones are easier to install and cheaper, but are inferior in detail.