Škoda Kodiaq windshield: dimensions, part numbers and 5 critical nuances when replacing

Replacing the windshield with Škoda Kodiaq - a task that every owner of this Czech crossover faces sooner or later. The reasons could be cracks from stones on the road, chips from hail, or even a manufacturing defect. But before you go to a service center or order glass yourself, you need to know it exactly sizes, articles of original and non-original analogues, and also take into account the features of the model - for example, the presence of sensors Lane Assist or cameras Front Assist.

In this article we will look at not only the standard windshield dimensions for all generations Kodiaq (including the 2021 facelift), but also nuances that are often overlooked: from the differences between the glasses for versions with panoramic roof to compatibility with driver assistance systems. You will also find step-by-step instructions for checking glass before purchasing and answers to frequently asked questions - for example, is it possible to install glass from Volkswagen Tiguan Allspace or Seat Tarraco.

Official windshield dimensions Škoda Kodiaq (2017–2026)

Standard windshield for Škoda Kodiaq (body NS7) has the following dimensions:

• 📏 Length (top edge): 1430–1450 mm (depending on the year of manufacture and configuration).
• 📐 Height: 850–870 mm.
• 🔄 Bend radius: ~2.5D (corners rounded for improved aerodynamics).
• 🖼️ Thickness: 4.8–5.2 mm (laminated triplex glass with PVB film).

Important: these parameters are relevant for basic versions Kodiaq without panoramic roof. If your car is equipped with a panoramic sunroof (optional 3F6 or 3F7), glass length may differ by ±10–15 mm due to changed roof geometry. More about this in the next section.

Original glass is produced by the company Saint-Gobain Sekurit (labeling SG) or Pilkington (labeling P) upon request Volkswagen Group. They must have a logo Škoda, article number and date of manufacture (usually in the format WWYY, where WW - week, YY - year).

Differences in glass for versions with panoramic roof

If your Kodiaq equipped with a panoramic roof (Panoramic Sunroof), the windshield will have increased length along the top edge - up to 1460 mm. This is due to the fact that the roof structure requires a displacement of the junction line between the glass and the body. In addition, such glasses often have:

• 🌑 Darker tint of the top stripe (up to 30% light transmission instead of the standard 70%).
• 🔍 Additional sound absorption layer (valid for 2020+ models).
• 📡 Built-in antenna for the system Keyless Entry (if option ordered).

Critical error: Attempt to install a standard windshield on a Kodiaq with a panoramic roof can lead to gaps up to 5 mm at the edges, which will cause wind noise at speeds above 120 km/h. When purchasing an analogue, be sure to check whether it is suitable for your configuration. For example, glass from Seat Tarraco (article 5Q0845001AN) are visually identical, but may not match the sensor mounts.

Model/equipment	Original article number	Length (mm)	Notes
Kodiaq (basic)	5Q0845001A	1430	Without panoramic roof, until 2020
Kodiaq (with panoramic roof)	5Q0845001AN	1460	Tinted top stripe, 2018–2026
Kodiaq RS	5Q0845001AQ	1440	Strengthened glass for high speeds
Seat Tarraco (analog)	5Q0845001AM	1435	Suitable for Kodiaq without panoramic roof

Compatible with other models and VW Group: is it possible to install glass from Tiguan or Tarraco?

Due to platform unification MQB windshields of some models Volkswagen Group interchangeable. However, there are nuances:

1. Seat Tarraco (2018–2026): glass with articles 5Q0845001AM and 5Q0845001AN suitable for Kodiaq the same year of manufacture. But check for sensor holes Travel Assist - on Tarraco they can be shifted 10–15 mm to the left.
2. Volkswagen Tiguan Allspace (2017–2023): glass is 50–70 mm shorter and does not fit. The exception is versions for the US market (5NA845001), but they require modification of the fastenings.
3. Audi Q7 (2015–2020): despite similar dimensions, the glasses are incompatible due to different angles of inclination and heating systems.

If you are considering non-original analogues, pay attention to the brands:

• 🔹 Pilkington (articles begin with NW): high quality, but often missing logo Škoda.
• 🔹 AGC Automotive (labeling AS): budget option, but may have defects around the edges.
• 🔹 XYG (China): cheap, but the risk of defects is ~15%. Check the certificate ECE R43.

Why shouldn't you buy glass from Tiguan?

U Tiguan Allspace and Kodiaq different windshield angles (65° vs 63°). This results in a distorted view through the camera. Area View and triggering false signals Front Assist.

How to Check a Windshield Before Buying: 5 Steps

Even original glass may have defects, so before installation be sure to:

☑️ Glass inspection checklist

Check the article for compliance with the vehicle VIN
Inspect the edges for microcracks (use a magnifying glass)
Make sure the markings are present ECE R43 (European standard)
Check compatibility with sensors (holes for Lane Assist)
Measure the thickness with a micrometer (should be 4.8–5.2 mm)

Done: 0 / 1

Pay special attention heating zone (heating threads should be evenly distributed, without breaks). If the glass has a tinted strip, check its light transmission: according to the standard ECE R43 it should not be lower than 70% for the main zone and 30% for the upper band.

⚠️ Attention: If there is no manufacturer's marking or production date on the glass, there is a high risk of buying a fake. Such glasses often have low-quality PVB film, which turns yellow after 1–2 years.

Step-by-step replacement instructions: what the owner needs to know

Replacing the windshield with Kodiaq takes 2–3 hours and requires special tools. If you decide to do this yourself, prepare:

• 🔧 Glass removal kit (string, suction cups).
• 🧴 Sealant SikaTack or 3M Urethane (don't skimp on quality!).
• 🔥 Hairdryer for heating the glue (temperature 60–80°C).
• 📱 Scanner for resetting sensor errors (for example, VCDS or OBDeleven).

Algorithm of actions:

1. Remove the wipers, plastic covers and rear view mirror.
2. Disconnect the battery (to avoid short circuits when working with sensor wires).
3. Heat the old sealant with a hairdryer and cut the glass with a string.
4. Clean the seat from residual glue and rust (use WD-40 and a brush).
5. Apply new sealant and install the glass, starting from the bottom edge.
6. Connect the sensors and perform calibration through the diagnostic scanner.

⚠️ Attention: After replacing the glass, be sure to calibrate the camera Front Assist and sensors Lane Assist! Without this, driver assistance systems will not work correctly and an error will appear on the dashboard ACC: Not Available.

💡

The use of poor-quality sealant can lead to glass peeling at speeds above 140 km/h. Saving 500–1000 rubles on glue is not worth the safety risk.

Replacement cost: original vs analogues

Prices for windshields for Škoda Kodiaq vary depending on type and manufacturer:

Glass type	Manufacturer	Price (RUB)	Delivery time
Original (with logo Škoda)	Saint-Gobain Sekurit	28 000–35 000	3–7 days
Analogue (premium)	Pilkington	18 000–24 000	1–3 days
Analog (budget)	XYG	12 000–16 000	5–10 days
Original (with panoramic roof)	AGC	32 000–40 000	7–14 days

Cost of replacement work in the service: 5,000–10,000 rubles (depending on the region). If sensor calibration is required, add another 2,000–3,000 rubles.

Tip: if your budget is limited, take glass Pilkington with article number NW5Q0845001 - it is identical in quality to the original, but is 30% cheaper. Avoid Chinese glass without a certificate ECE R43, as they may not be able to withstand the impact of a stone at speed.

Common mistakes when choosing and installing

Even experienced craftsmen sometimes make mistakes that lead to problems. Here are the most common:

• 🚫 Ignoring the year of manufacture: glass for Kodiaq 2017 and 2021 may differ in sensor mounts.
• 🚫 Saving on sealant: Cheap glue loses its elasticity after 1–2 years, which leads to leaks.
• 🚫 Incorrect calibration: If sensor errors are not reset, the system Adaptive Cruise Control will be disabled.
• 🚫 Installation without warming up: The sealant must be applied at a temperature not lower than +10°C, otherwise it will not polymerize.

If after replacement you notice the following symptoms, contact service immediately:

• 💨 Wind whistling at speeds above 100 km/h (a sign of a loose fit).
• 🚨 Error Lane Assist: Faulty on the dashboard.
• 🌧️ Moisture under plastic covers (sealant leakage).

💡

If after replacing the glass an error appears on the panel Camera Malfunction, that means the sensor Front Assist not connected or damaged. It is impossible to fix this on your own - you need diagnostics.

FAQ: answers to frequently asked questions

Is it possible to drive with a crack in the windshield? Kodiaq?

If the crack is less than 10 cm and is not in the driver’s field of vision (according to GOST - no closer than 290 mm from the steering wheel), you can drive. However, in the event of an accident, the insurance company may refuse to pay, citing a malfunction. The crack can also spread due to temperature changes (for example, when the glass heating is turned on).

What sealant is best to use for installation?

Optimal options:

• SikaTack Drive — polymerizes in 1 hour, can withstand up to +120°C.
• 3M Urethane Adhesive - universal, suitable for all climate zones.
• Dow Betaseal — premium option, used in official services Škoda.

Do not use silicone sealants - they do not provide sufficient strength.

What should I do if noise appears after replacing the glass?

Causes and solutions:

1. Loose fit: You need to reinstall the glass with a new layer of sealant.
2. Seal defect: Check the rubber seals around the edges.
3. Uncalibrated sensors: Reset via VCDS.

Is glass suitable from Skoda Karoq?

No, Karoq in short Kodiaq by 200 mm, and its windshield has different mountings for wipers and sensors. The exception is glass from Karoq Scout (article 5Q0845001AX), but they require improvement.

How to check whether the original glass is installed?

The original glass has:

• Logo Škoda in the lower left corner.
• Marking SG or P (manufacturer).
• Date of manufacture in format WWYY.
• Hologram ECE R43 in the upper right corner.

If at least one of these elements is missing, the glass is not original.