glove box in Ε koda Octavia A5 (2004–2013) - a seemingly simple detail, but dismantling it can turn into a real puzzle if you don’t know the nuances. Unlike newer models, where the plastic latches are standardized, A5 combined fastenings: there are also screws for Torx T20, and hidden clips, and even a bolt under 10mm key in some trim levels. You have to remove the glove compartment for various reasons - from banal cleaning to replacing a backlight bulb or repairing the fuse box hidden behind it.

In this article you will find step-by-step instructions with photos, analysis of typical mistakes (for example, why latches break when removed carelessly), as well as tips on choosing tools. We took into account the features of different modifications Octavia A5 - from basic 1.4 MPI to top RS with climate control, where access to the glove compartment is blocked by an additional panel. If you have never disassembled the interior, do not worry: with the right approach, the operation will take no more than 20 minutes.

Preparation: Tools and Precautions

Before you begin, make sure you have everything you need. B Octavia A5 The glove compartment is mounted on mixed elements, so a universal screwdriver will not be enough. Here minimal set of tools:

  • πŸ”§ Phillips screwdriver PH2 (for screws at the bottom of the glove box)
  • πŸ”© Bat Torx T20 with ratchet or screwdriver (for side mounts)
  • πŸ”§ Flathead screwdriver or plastic pick (to separate clips)
  • πŸ”¨ Key on 10 mm (only for versions with metal bracket)
  • πŸ“¦ Container for small parts (screws are easily lost in the interior!)

Pay special attention plastic clips. B Octavia A5 they often break if removed carelessly, and original spare parts (article no. 1Z0 857 531) are not cheap. If the clips are already damaged, buy a repair kit in advance - for example, from Febi Bilstein or Hella.

⚠️ Attention! Do not attempt to remove the glove compartment without disconnecting the negative terminal of the battery. In some configurations, the backlight and opening sensor wires pass behind it, which can be accidentally shorted.

Also prepare your workspace:

  • πŸš— Place the car on a flat surface and lock the handbrake.
  • πŸ”¦ Use a flashlight - the recesses under the glove compartment are often dark.
  • πŸ“Έ Take a photo of the location of the wires and connectors before disconnecting (useful for reassembly).
πŸ“Š Why do you need to remove the glove compartment?
  • Interior cleaning
  • Fuse box repair
  • Replacing the backlight lamp
  • Installation of additional equipment
  • Other

Step-by-step instructions: how to remove the glove compartment on an Octavia A5

The dismantling process can be divided into 4 stages. Follow the instructions strictly in order to avoid damage. Let's start with preparation:

  1. Open the glove compartment and delete all contents. Some versions (eg backlit) may have a lamp inside - carefully remove it by turning it counterclockwise.
  2. Lower the glove compartment down all the way. At the bottom you will see two screws under PH2 β€” they need to be unscrewed first.
  3. Remove the decorative trim on the left (if there is one). It is attached to clips - use a flat-head screwdriver to pry it off at the base.

Now let's move on to the main fastenings:

β˜‘οΈ Removing the glove compartment Octavia A5

Done: 0 / 5
Stage Action Tool Note
1 Unscrew the bottom screws Screwdriver PH2 Screws can be hidden with plugs
2 Remove the side trims Plastic pick Start on the left side - the clips are weaker there
3 Unscrew the bolts Torx T20 Bat Torx T20 In some versions there are latches instead of bolts
4 Disconnect connectors Hands Do not pull on the wires - only on the connector housing!

After unscrewing all the fasteners, carefully pull the glove compartment towards you. It should come out of the grooves without effort. If you feel resistance, check:

  • πŸ” Did you forget the screw under 10mm key (available in versions with a metal frame).
  • πŸ”Œ Is the opening sensor connector (usually black, with a latch) disconnected?
  • πŸ“‹ Does the wiring from the backlight or the seat heating button (in complete sets) interfere? Ambition and Elegance).
⚠️ Attention! On models with climate control, the air conditioning pipe runs behind the glove compartment. Do not touch it - risk of damage and leakage of freon!
πŸ’‘

If the glove box gets stuck when removing, do not use force. You most likely missed the hidden clip. Shine a flashlight on the right side - an additional mount is often hidden there.

Features of dismantling in different versions of Octavia A5

Ε koda Octavia A5 was produced in several modifications, and the glove compartment design in them is different. Here are the key details:

Basic version (1.4 MPI, 1.6 MPI)

Here the glove compartment is attached only to 4 screws (PH2 below and Torx T20 on the sides). There is no backlight, so there is no need to disconnect the connectors. The main problem is the fragile clips of the decorative trim, which often break the first time they are removed.

Ambition and Elegance trim levels

These versions added:

  • πŸ’‘ Backlight lamp (item no. 6Q0 947 105) with connector.
  • πŸ”„ Glove box opening sensor (connected to the comfort unit).
  • πŸ”₯ Additional bolt 10 mm in the upper right corner (only for machines with a metal bracket).

Octavia RS and models with climate control

The most complex design:

  • 🌑️ The air conditioning pipe runs behind the glove compartment - it must not be bent.
  • πŸ”Œ Additional fuse box (SC-33) is attached to the rear wall of the glove compartment.
  • πŸ”§ The fastenings are reinforced - instead of plastic clips, metal latches are used.

On models with heated seats, the wiring harness to the control buttons runs behind the glove compartment. It must not be disconnected without first removing the negative terminal of the battery - risk of short circuit!

How do you know what equipment you have?

Look at the VIN number (first 3 characters):

- TMB β€” basic version (1.6 MPI).

- BZB or BZC β€” Ambition/Elegance (1.8 TSI or 2.0 TDI).

- 1Z3 β€” Octavia RS.

The equipment can also be determined by the presence of climate control (two knobs instead of three) and glove compartment lighting.

Common mistakes and how to avoid them

Even experienced car owners make mistakes when removing the glove compartment. Here TOP-5 problems and ways to prevent them:

  1. Broken clips. The reason is an attempt to detach the pickguard without a pick. Always use a plastic tool, not a screwdriver!
  2. Lost screws. Screws Torx T20 small and easily fall into the cracks of the cabin. Before work, lay a light cloth on the floor.
  3. Damaged backlight. The lamp is fixed with a fragile plastic socket. Do not pull on the wire - first press the socket and turn it counterclockwise.
  4. Shorted wires. If you don't disconnect the battery, you might blow the fuse. F37 (responsible for the cigarette lighter and lighting).
  5. Bent metal brackets. In versions with bolt 10 mm Often the fasteners are overtightened. Tighten no more than 5 Nm.

Another common mistake is incorrect assembly. After installing the glove compartment, check:

  • πŸ”Ή Door movement (it should open smoothly, without squeaks).
  • πŸ”Ή The operation of the backlight (if any) - sometimes the lamp does not light due to the misalignment of the socket.
  • πŸ”Ή Fixation of decorative overlays - they should not β€œplay” when pressed.
πŸ’‘

If after assembly the glove compartment does not close completely, check the position of the side clips. Often they stand crooked due to deformation of the plastic. The solution is to carefully bend them with pliers.

What to do if the glove compartment is broken: repair and replacement

If you damage the glove compartment during dismantling, do not rush to buy a new one. Many problems can be solved by repair:

Problem Reason Solution Cost (RUB)
Case cracked Excessive force when removing Glue plastic Loctite 406 + reinforced with fiberglass 300–500
Broken clips Inaccurate removal of pads Replace with new ones (article no. 1Z0 857 531) 200–400 per set
Backlight doesn't work The lamp has burned out or the contacts have oxidized Replace the lamp (6Q0 947 105) or clean the connector 150–300
The door does not lock Broken retainer or spring Replace the lock mechanism (part number 1Z0 857 521) 800–1200

If repair is impossible, you will have to buy a new glove compartment. Original part (1Z0 857 009) costs from 5,000 rubles, but you can find analogues from Hella or Topran cheaper (from 2,500 rubles). When choosing, pay attention to:

  • πŸ” Plastic color (must match the interior - the paint code is on a sticker in the glove compartment).
  • πŸ”§ Presence of holes for lighting (if it was included in your package).
  • πŸ“ Dimensions β€” in restyled models (2009–2013) the glove compartment is 1 cm wider.

When installing a new glove compartment, do not forget to move the old backlight lamp (if it is working) and the opening sensor. Their fastenings do not always match the new parts.

Tips for servicing the glove compartment after removal

When the glove compartment is removed, it is worth at the same time preventive maintenance:

  • 🧹 Cleaning: Remove dust and debris from the niche under the glove compartment. Leaves, coins and even insect nests often accumulate there.
  • πŸ’‘ Backlight: If the lamp is dim, clean the socket contacts with sandpaper (P1200).
  • πŸ”Œ Wiring: Check the integrity of the wire insulation, especially if there have been leaks in the interior.
  • πŸ”§ Fastenings: Lubricate the plastic clips with silicone grease - this will extend their service life.

If you removed the glove compartment to access the fuse box (SC-33), inspect it for oxidation. B Octavia A5 often fail:

  • πŸ”₯ fuse F37 (10A) - responsible for the cigarette lighter and glove compartment lighting.
  • πŸ”₯ fuse F41 (15A) - controls climate control (in configurations Elegance).
  • πŸ”₯ Relay J317 β€” if the heated seats do not work.

After all the manipulations, assemble the glove compartment in the reverse order. Don't forget to check the operation of all systems:

  • πŸ”Ή The backlight turns on when the door is opened.
  • πŸ”Ή The glove compartment opening sensor transmits a signal to the on-board computer (if equipped).
  • πŸ”Ή There are no extraneous squeaks when opening/closing.

FAQ: Frequently asked questions about the Octavia A5 glove compartment

Is it possible to remove the glove box without a Torx screwdriver?

Theoretically yes, but not recommended. Screws Torx T20 have a specific shape, and a Phillips screwdriver can β€œlick” the slots. As a last resort, use a flathead screwdriver with a thin blade, but be careful.

Why doesn't the glove compartment close all the way after assembly?

The reasons may be different:

  • The plastic guides are skewed (need to be aligned).
  • The side screws are not fully tightened Torx T20.
  • The wiring is in the way - check to see if the harness is caught in the groove.

Solution: Remove the glove compartment again and check all fastenings.

Where to buy clips for the Octavia A5 glove compartment?

Original clips (1Z0 857 531) can be ordered from official dealers Ε koda or in online stores:

  • Exist.ru (article 1Z0857531).
  • Autodoc (analogues from Febi or Hella).
  • Auctions (eg eBay with filter by VIN number).

Cost - from 50 rubles per piece. Buy with a reserve, as clips often break during installation.

How to remove the glove compartment if the lock latch is broken?

If the latch (article no. 1Z0 857 521) is broken and the door does not hold, proceed as follows:

  1. Remove the glove compartment according to the instructions above.
  2. Disconnect the broken fastener (it is secured by two latches).
  3. Install the new mechanism and check the door movement.

Temporary solution: Secure the door with a zip tie or rubber band, but this is inconvenient in the long run.

Is it possible to paint the glove compartment of an Octavia A5?

Yes, but there are nuances:

  • Use plastic paint (eg Motip Plastic Paint).
  • Degrease the surface before painting Antisilicon.
  • Apply paint in 2-3 thin layers with intermediate drying for 15 minutes.

Select the color according to the interior code (located on the plate in the glove compartment or on the door pillar).