Lamps in the ŠKODA Octavia Tour: A Complete Guide to Replacement and Choice

Owners ŠKODA Octavia Tour sooner or later they face the need to replace lamps - whether it is a burned out passing light, dim dimensions or a broken stop light. At first glance, the procedure seems simple, but in practice, many are faced with nuances: from the selection of the right articles to the difficulties with access to the lamps of the taillights. This article will help you understand all the subtleties - from standard halogen lamps to modern LED solutions, and also warn against typical errors that can lead to short circuit or damage to the light control unit.

Feature Octavia Tour (in bodies 1Z, 5E and NX) is a combined lighting system where part of the lamps are unified with the sedan and part is unique to the station wagon. For example, the taillights here have a different design, which affects the replacement process. We will analyze each type of lamp in detail - from front lights to cabin lighting - we will specify the original articles and analogues, as well as give step-by-step instructions taking into account the generation of the car.

Types of lamps in the ŠKODA Octavia Tour: what is where

Lighting configuration in Octavia Tour It depends on the year of release and configuration. For example, in the basic versions before 2013 (see below).1Z) halogen lamps were often installed H7 for near/far light, whereas in facelift models (5E After 2017, LED options appeared. Below is a complete list of lamps with an indication of their location and types.

Important: Even if your car is equipped with xenon or LED optics, some lamps (such as dimensions or turn signals) remain halogen. This is due to the legislative norms and design features.

• 🔦 Low beam: H7 (halogen) or D1S/D3S (xenon), in LED versions - non-collectible modules.
• 💡 High beam: H1 (halogen) or integrated into a bixenon module.
• 🟡 Turn signals: PY21W (yellow basement lamp) or non-base lamps WY5W in the rear lights.
• 🚦 Side lights: W5W (front) and P21/5W (Rear, combined with a stop light).
• 🛑 Brake lights: P21W or P21/5W (in combination lamps).
• 🔴 Reverse: W16W or W21W (depending on the year).
• 🌐 Fog lights: H11 (front) and P21W (rear).
• 🚗 Salon/baggage: C5W, W5W Or LED boards in new models.

B Octavia Tour third generation (NXSince 2020, there have been fully LED taillights, where lamps as such are absent - indissoluble modules are used instead. Attempt to replace them yourself may void the warranty.

How to choose lamps: halogen vs LED vs xenon

The choice of the type of lamp depends not only on preferences, but also on the design of the headlight. For example, install LED lamps in halogen optics Octavia Tour first generation (1Z) technically possible, but this may lead to blinding oncoming drivers and problems with passing technical inspection. Let's look at the pros and cons of each option.

Lamp type	Pros	Cons	Compatible with Octavia Tour
Halogen	Low price, simple replacement, legality	Low luminous flux, short service life (300–500 hours)	All generations except full LED versions
Xenon	Bright light (2-3 times brighter than a halogen), long service life (2000-3,000 hours)	Expensive lamps and ignition blocks require a headlight corrector	Only in the standard configuration (for example, D1S in Octavia Tour RS)
LED lamps	Energy efficiency, durability (up to 50,000 hours), modern design	High price, risk of overheating, possible errors on the instrument panel	Only in the optics with a projector (e.g., Octavia Tour 2020+)

For Octavia Tour second generation (5E2013–2020) LED lamps with a base are popular H7 from brands Osram or PhilipsBut their installation requires improvement: often you have to cut the anther headlights or use additional resistors to eliminate errors. Third generation (art.NX) LED optics are coming from the factory and there is no replacement of the lamps there - only replacement of the entire module.

⚠️ Attention: Installation of LED lamps in halogen optics without headlight corrector can lead to a fine for non-compliance with GOST R 51709-2001. Check the angle of light shade on the stand!

Step-by-step replacement of low and high beam lamps

Replacing headlight bulbs Octavia Tour One of the most frequent procedures. Depending on the generation, the lamps are accessed either through the hood space or from the bumper side (in newer models). Let's look at the process by example. Octavia Tour 5E (2013-2020).

Tools: gloves (so as not to leave greasy marks on the flask), a screwdriver with a flat sting, a key for 10 (for removing the bumper in difficult cases).

Remove the negative terminal from the battery

Clean the headlight from dirt

Prepare a new lamp (do not touch the bulb with bare hands)

Check the safety circuit (F3 and F13 for passing beam)

-->

1. Open the hood and locate the rear part of the headlight unit. On Octavia Tour It's covered with a plastic cover that's removed by turning counterclockwise.

2. Disconnect the power connector from the lamp by pressing the lock (on the lamps) H7 It's black, on the H1 - gray.

3. Remove the spring clip that holds the lamp in the socket. To do this, press on it from above and move it to the side.

4. Remove the old lamp and install a new one, without touching the flask (fat traces reduce service life).

5. Reassemble everything in reverse order and check the light operation before installing the cover - this will simplify diagnostics if the lamp does not light up.

B Octavia Tour NX (2020+) to replace low beam lamps (H7 or LED module), it may be necessary to remove the bumper or part of the air duct. If you are not confident in your abilities, it is better to contact the service - an error during assembly can lead to moisture getting into the headlight.

What should I do if the lamp does not light after replacement?

If the new lamp does not work, check:

1. **Fuses** (in the block under the steering wheel: F3 - low beam of the left headlight, F13 - right).

2. **Contacts in the connector** - they often oxidize, especially in damp weather.

3. **Polarity** - some LED lamps are sensitive to connection polarity.

4. **Light control unit** (J519 or J745) - if short circuited, it can turn off the circuit.

Replacing lamps in the rear lights: nuances of the Octavia Tour

Tail lights Octavia Tour have a more complex design than a sedan due to the increased luggage compartment. In models 1Z and 5E to access the lamps you need to remove the trunk trim, whereas in NX Some of the lamps are changed through the hatch in the trunk, and some are changed only from the bumper side.

Typical problems:

• 🔧 Souring of cartridges due to moisture ingress (especially in reversing lamps W16W).
• 🔌 Broken wiring due to careless removal of the casing.
• 🚨 Errors on the instrument panel after replacing LED lamps (installation of resistors or coding via VCDS).

To replace brake/side light bulbs (P21/5W):

1. Remove the plastic plug in the trunk (it is secured with latches).

2. Unscrew the two screws securing the flashlight (wrench 8 or 10).

3. Carefully pull the flashlight out, do not pull on the wires!

4. Turn the socket counterclockwise and remove the lamp.

⚠️ Attention: B Octavia Tour 5E when replacing a reverse lamp (W16W) the plastic cartridge often breaks. Buy a spare one in advance (item no. 5E2 945 009)!

Interior lighting and trunk lamps

Interior lighting lamps in Octavia Tour They rarely fail, but replacing them can be difficult due to the fragile plastic fasteners. In older models (1Z) lamps are used C5W, in new (NX) - LED boards that cannot be replaced separately from the lampshade.

Where to look:

• 🚪 Interior lighting: snap-on, lamp W5W or C5W.
• 📦 trunk: lamp W5W (in 5E) or LED module (in NX).
• 🔍 Glove compartment lighting: miniature lamp T4W (in complete sets with lighting).
• 🚗 Foot lighting: LEDs, only the entire unit can be replaced.

To replace the interior lamp:

1. Use a screwdriver to pry out the plastic lens (it is held on by latches).

2. Remove the lamp by pulling it towards you.

3. Install a new lamp same power (for example, W5W 12V 5W).

Common mistakes when replacing lamps and how to avoid them

Even experienced car owners make mistakes that lead to repeated replacement of lamps or serious damage. Here are the most common ones:

1. Touching the bulb of a halogen lamp with bare hands. Fatty traces lead to local overheating and reduced service life. Use gloves or wipe the flask with alcohol.

2. Use of high power lamps. For example, setting H7 100W instead of regular ones 55W leads to melting of the cartridge and wiring.

3. Wrong polarity of LED lamps. If the lamp does not light up, turn it 180 degrees in the socket.

4. Ignoring errors on the instrument panel. After replacing the LED bulbs, the "Check Light" indicator may light up. This requires installation decoy (6.8 Ohm resistors) or software disabling control through a diagnostic scanner.

5. Closing the headlight cover without checking. If the lamp is installed incorrectly, moisture will get inside and the headlight will have to be dried or replaced.

B Octavia Tour 5E With factory LED headlights, attempting to replace a burnt-out diode yourself will void the warranty. In such cases, official dealers offer replacement of the entire module (cost from 15,000 rubles).

FAQ: answers to frequently asked questions

What kind of lamps are in foglights? Octavia Tour 2015?

The front fog lights use a bulb H11 (halogen, 55W). In the rear - P21W. For LED analogs, models from Osram LEDriving FOG or Philips X-tremeUltinon, but the fastenings will require modification.

Is it possible to install xenon in halogen headlights? Octavia Tour 1Z?

Technically possible, but illegally. For legal installation you need:

• Headlights with lens and markings DCR (for xenon).
• Headlight washer.
• Autocorrector.
• Certificate of conformity.

Without this, you will receive a fine of 500 rubles (Article 12.5 of the Administrative Code) and will not pass the technical inspection.

Why after replacing the low beam lamp in Octavia Tour NX is there an error?

New models use a lamp control system (BULB MONITORING). When installing LED lamps, the control unit detects a change in resistance and generates an error. Solutions:

1. Install dummy resistors (6.8 Ohm, 50W) parallel to the lamp.
2. Disable control via diagnostics (VCDS or OBDeleven).
3. Use lamps with built-in decoys (for example, Morimoto 2Stroke 2.0).

How to remove a headlight Octavia Tour 5E to replace the lamp?

Procedure:

1. Remove the bumper (unscrew the 4 screws on the bottom and 2 bolts on the sides).
2. Unscrew the three headlight mounting bolts (two on top, one on bottom).
3. Disconnect the power connectors (low beam, turn signal, corrector).
4. Carefully pull out the headlight, do not pull on the wires!

To replace the lamp H7 It is not necessary to remove the headlight - access through the engine compartment is sufficient.

What are the dimensions of the lamps? Octavia Tour 2020?

In the front dimensions - W5W (baseless), in the rear - a combined lamp P21/5W (brake light + clearance). In top trim levels (Style, RS) dimensions are made with LEDs and cannot be replaced separately.