Škoda Superb second generation (code designation 3T) is a car that combines business class comfort and station wagon practicality. When selecting rims or tires, owners are often faced with the question: what is the bolt pattern? Superb 2? An error in the parameters can lead to vibrations, accelerated wear of wheel bearings, or even an emergency.

In this article - precise technical data by bolt pattern, offset (ET), diameter of the central hole (DIA) and recommended wheel/tire sizes for all modifications Superb 2 (2008–2015). We will also look into unique nuances of wheel selection for versions with 4×4 all-wheel drive and diesel enginesthat are often overlooked.

1. Bolt pattern Škoda Superb 2: basic parameters

The main parameter that determines the compatibility of a disk with a hub is PCD (Pitch Circle Diameter), or a bolt pattern. For Škoda Superb 2 (including the 2013 facelift) it is the same for all trim levels:

  • 🔧 PCD: 5×112 (5 holes located on a circle with a diameter of 112 mm).
  • 📏 offset (ET): from +35 up to +45 mm (depending on the width of the disk).
  • ⭕ Center Hole Diameter (DIA): 57.1 mm.
  • 🔩 Thread of mounting bolts: M14×1.5 (bolt length - 27–30 mm).

These parameters are unified with other models of the concern Volkswagen Group on the platform PQ46, for example, VW Passat B6/B7 or Audi A4 B7/B8. However using disks from Audi without adapters is not possible due to the different diameter of the central hole (for Audi — 66.6 mm).

⚠️ Attention: PCD discs 5×100 (for example, from Škoda Octavia A5) can visually “sit” on the hub, but when moving this will lead to steering wheel beating and damage to bolt threads. It is strictly forbidden to use them!

2. Disk compatibility table by size

The manufacturer allows several wheel sizes for Superb 2, depending on the engine and configuration. Below is the official data from the manual Škoda (valid for models 2008–2015):

Rim Width (inches) Disc Diameter (inches) Reach ET (mm) Recommended tire size Notes
6.5J 16 +45 205/55 R16 Basic equipment (1.4 TSI, 1.6 MPI)
7J 17 +42 215/50 R17 Sports package, 2.0 TSI, 3.6 FSI
7.5J 18 +38 225/45 R18 Only for versions with adaptive suspension
8J 19 +35 235/40 R19 Option for Superb 2 FL (facelift)

For vehicles with all-wheel drive 4x4 (for example, 2.0 TDI 4×4 or 3.6 FSI 4×4) the minimum offset must be at least +38 mm. Using discs with ET < 35 will lead to hitting the suspension elements when the steering wheel is turned completely.

📊 What size rims does your Superb 2 have?
  • 16 inches
  • 17 inches
  • 18 inches
  • 19 inches
  • Other

3. How to check the bolt pattern on your car

If you are not sure about the parameters or are buying used wheels, check the PCD yourself. To do this you will need a caliper or ruler:

  1. Measure the distance between the centers of two adjacent bolt holes (denoted as X).
  2. Multiply X by the coefficient 1.051 (for 5 holes). The resulting value is the diameter of the circle (PCD).

Example: if the distance between holes 64.7 mm, then 64.7 × 1.051 ≈ 68 mm. However for Superb 2 PCD must be straight 112 mm - this confirms the originality of the disc.

Measure PCD (should be 5×112)

Check the diameter of the central hole (57.1 mm)

Make sure the offset (ET) is as shown in the table above.

Inspect the disc for cracks or deformations -->

⚠️ Attention: There are “universal” PCD discs on the market 5×112/5×114.3, where the holes are oval. Such disks unacceptable for Superb 2 - they do not provide accurate alignment and can cause imbalance at high speeds.

4. Selection of tires: what the manufacturer says

Škoda recommends using tires with a speed rating of at least H (up to 210 km/h) and load index from 91 (for 1.4 TSI) up to 99 (for 3.6 FSI). Important details:

  • ❄️ For winter tires, a reduction in width of 10–15 mm is allowed (for example, 205/55 R16 instead of 215/50 R17).
  • 🔥 Summer tires with low profile pattern (40 and below) reduce comfort on rough roads.
  • 🛞 For versions with DSG critical equal tire wear on the same axis - a difference of more than 2 mm can cause jerking of the box.

Example of tire markings suitable for Superb 2:

215/50 R17 91H XL

Where:

  • 215 - width in mm,
  • 50 - profile (50% of width),
  • R17 — radial tire on a 17-inch wheel,
  • 91H — load/speed index,
  • XL — reinforced design (recommended for heavy engines).
💡

When purchasing tires, check the production date (last 4 digits of the DOT code). Tires older than 5 years lose their elasticity, even if they look new.

5. Frequent mistakes when selecting wheels and tires

Owner experience Superb 2 shows that the most common problems are related to:

  1. Ignoring the departure (ET): Discs with ET 30 (for example, from Audi S4) are visually suitable, but move the wheel outward, increasing the load on the wheel bearings.
  2. DIA mismatch: Centering rings (adapters) solve the problem only partially - without them the disk will not be firmly fixed to the hub.
  3. Installing tires of the wrong diameter: For example, 235/40 R18 instead of 225/45 R18 may hit the arches when fully loaded.

It is especially dangerous to install disks with incorrect PCD. For example, PCD 5×108 (from BMW 5-series) looks similar to 5×112, but when moving this will lead to:

  • 🔧 Spontaneous loosening of bolts due to uneven load.
  • 🚗 Vibrations at speeds above 100 km/h (especially noticeable on the steering wheel).
  • 💥 Hub destruction during long-term use.
What should I do if I bought discs with the wrong PCD?

If the drive is already purchased and has a 5x100 or 5x114.3 PCD, the only safe option is to sell it and purchase the correct one. The use of adapter plates or "eccentric" bolts does not guarantee reliability and can lead to accidents. As a last resort, you can bore the holes for PCD 5x112 with a lathe, but this will reduce the strength of the disk.

6. Facelift 2013: are there any differences?

Škoda Superb 2 after facelift (2013–2015) received minor design changes, but bolt pattern parameters remained the same. However, there are nuances:

  • 🔄 For versions with adaptive suspension DCC (Dynamic Chassis Control) recommended flight — ET 38–42 (even for 17-inch wheels).
  • 🔋 For hybrid version Superb 2 GreenLine (1.6 TDI) only wheels with ET ≥ 40 due to the increased weight of the battery.
  • 🎨 Discs with two-tone paint (for example, Anthracite) require careful care - they cannot be cleaned with aggressive agents (for example, acid-based).

Owners of restyled versions should also pay attention to Tire Pressure Sensors (TPMS). If new drives are being installed, the sensors may need to be moved or reprogrammed via VCDS (diagnostic scanner for VAG).

💡

Even if externally the wheels from the pre-facelift and restyled versions of Superb 2 seem the same, always check the car’s VIN code when selecting. Some dealers mistakenly offer wheels from Superb 3 (PCD 5x112, but DIA 66.6 mm), which do not fit without adapters.

7. Where to buy wheels and tires for Škoda Superb 2

When choosing a place of purchase, focus on:

  • 🏆 Official dealers Škoda: Guarantee of original spare parts, but prices are 20–30% higher than the market.
  • 🛒 Specialized online stores (for example, Koleso.ru, Shina.ru): There is often a filter based on PCD/ET/DIA parameters.
  • 🔧 Local tire shops: You can try on the disc before purchasing, but the range is limited.
  • 🌍 Foreign sites (for example, Amazon DE, Ebay): Prices are lower, but delivery costs are high and there is a risk of counterfeits.

When purchasing used drives, be sure to check:

  1. No cracks (especially around bolt holes).
  2. Evenness of the surface (roll the disc on a flat surface - it should not “play”).
  3. The condition of the paintwork (corrosion can hide metal defects).
⚠️ Attention: When purchasing tires complete with rims ("shod" wheels) make sure that the tires no older than 3 years (see date on side). Storing tires on rims in improper conditions (for example, stacked) leads to deformation of the cord.

FAQ: Frequently asked questions about the bolt pattern of the Škoda Superb 2

Is it possible to install 5x114.3 disks using adapters?

Technically yes, but this not recommended. Adapters increase reach by shifting the center of gravity of the wheel, which worsens handling. In addition, adapters must be certified for your model, otherwise the insurance company may refuse to pay in case of an accident.

What is the minimum offset (ET) allowed for the Superb 2?

For most versions - ET 35. However, for vehicles with all-wheel drive (4×4) minimum reach - ET 38. Installing disks with ET < 35 requires widening of wheel arches or the use of spacers, which illegally in most countries.

Will rims from Volkswagen Passat B6 fit?

Yes, VW Passat B6/B7 has identical bolt pattern parameters (5×112, DIA 57.1). However, check the departure: Passat it can be 2–3 mm smaller, which is not critical, but increases the load on the bearings.

Is it possible to install tires with a higher profile (for example, 60 instead of 55)?

Yes, but this will affect the speedometer (it will lower the speed by ~2-3%) and may cause problems with operation ESP. For an accurate calculation, use a tire size calculator (for example, on the website TyrePlus).

Do I need to balance wheels after replacing rims?

Definitely! Even new discs can have imbalances. Balancing is performed on a special machine, installing weights on the inside of the disk. For Superb 2 with the system DSG An imbalance of more than 5 grams can cause jerking when changing gears.