Right mirror on Škoda Fabia 2: how to select, remove and install it yourself

Rear view mirrors Škoda Fabia 2 (2007–2014) is a critical element of safety, especially when it comes to right mirror, which more often suffers from mechanical damage in parking lots or in road accidents. Owners of this model are often faced with the need for replacement: be it a crack in the glass, a malfunction of the electric drive (in versions with electric heating) or a broken fastener. In this article we will look at everything you need to know about the right mirror. Fabia 2 - from the selection of original and analog spare parts to step-by-step instructions for do-it-yourself replacement.

Feature Fabia 2 is that the right mirror (passenger) has a unique shape and mount, different from the left (driver's). This means that mirrors from other Škoda or Volkswagen models will not fit without modifications, even if they look similar in appearance. We analyzed the article numbers, prices for new and used parts, and also collected reviews from owners about the reliability of analogues. If you are planning a repair yourself, here you will find photos of fasteners, connection diagrams (for heated versions) and tips on how to avoid common mistakes.

Right mirror design Škoda Fabia 2: what's inside?

Right mirror on Fabia 2 consists of several key components, each of which can fail:

• 🔹 Mirror housing - a plastic base attached to the door. Often breaks when impacted or over time (plastic becomes brittle).
• 🔹 Mirror glass - can be normal or with electrically heated (in configurations Ambition and Elegance).
• 🔹 Adjustment mechanism — cable (in basic versions) or electric (in top trim levels).
• 🔹 Wiring and connectors — in heated mirrors there is a wiring harness, which often frays at the entrance to the door.

Electric versions are equipped with motors for remote adjustment of the tilt angle. If the mirror does not respond to the buttons on the driver's door, the problem may lie in:

• 🔋 faulty motor;
• 🔌 oxidized contacts in the connector;
• ⚡ blown fuse F30 (10A) in the block under the steering wheel.

Before purchasing a new mirror, check the circuit with a multimeter. Often the problem is solved by cleaning the contacts or replacing the fuse.

Articles and prices: original vs analogues

Original right mirror for Škoda Fabia 2 (2007–2014) has an article number 6Y1857507B (without heating) or 6Y1857507D (heated). The cost of a new original in official dealers starts from 12,000 rubles, but at disassembly sites you can find used options for 3,000–5,000 rubles. Important: when buying a used one, check the functionality of the heating and adjustment mechanism!

Among the analogues, the following have proven themselves well:

Brand	Article	Price, rubles	Features
Hella	8GC 008 109-001	7 500–9 000	High quality plastic, precise fit
Bosch	1 987 429 004	8 200–10 000	Suitable for heated versions
Megaflon	MFL-0123	4 500–6 000	Budget option, possible backlash
Valeo	483501	9 000–11 000	Original quality, but more expensive than analogues

When choosing an analogue, pay attention to:

• 🔧 Mounting type - must match the original (3 bolts on Fabia 2).
• 🔌 Availability of connector for heating (if it is provided in your configuration).
• 📏 Glass shape — some analogues have distorted optics.

⚠️ Attention: Mirrors from VW Polo 9N (2002–2009) are similar in appearance, but have a different mount and will not fit without modifications!

Step-by-step instructions: how to remove the right mirror

To dismantle the mirror you will need:

• 🔧 Socket wrench on 10 mm;
• 🔧 Flat head screwdriver;
• 🔧 Plastic puller (or knife with a blunt end);
• 🔧 Electrical tape (to secure the door in the open position).

Sequence of actions:

1. Open the right front door and secure it in the open position (for example, with rope or tape) to prevent damage to the wiring when removing the trim.

2. Remove the plastic door card trim (three clips at the bottom and one under the handle). Carefully pry it off with a screwdriver, starting from the bottom corner.

3. Unscrew the three mirror mounting bolts (they are hidden under the trim). The bolts may be stuck - do not use excessive force to avoid stripping the threads.

4. Disconnect the wiring connector (if the mirror is heated or electric). The connector is usually secured with a plastic latch - press it and pull it down.

5. Remove the mirror from the door by pulling it towards you. Be careful: in some cases, a rubber seal remains between the mirror and the door.

If the mirror cannot be removed despite the bolts being unscrewed, check to see if there are any hidden clips left. On some versions Fabia 2 (for example, facelift 2010) an additional plastic retainer is used in the upper part of the mount.

⚠️ Attention: When disconnecting the connector, do not pull the wires - they may come off the board inside the mirror. If the contacts are oxidized, clean them with alcohol before connecting a new mirror.

Installing a new mirror: nuances and common mistakes

Installation of a new mirror is carried out in the reverse order, but there are several critical points:

1. Before installation, check the integrity of the rubber seal between the mirror and the door. If it is torn, replace it (part no. 6Y1857671).

2. When connecting the connector, make sure that the contacts match. On heated mirrors, the connector has 4 contacts (two for heating, two for adjustment).

3. Tighten the mounting bolts crosswise to avoid distortion of the mirror. Tightening torque - 8–10 Nm.

4. After installation, check the operation of the heating (if provided): turn on the ignition and press the rear window heating button - after 1-2 minutes the mirror glass should heat up.

Typical installation errors:

• 🚫 Overtightened bolts - lead to cracks in the plastic mirror housing.
• 🚫 Incorrect connector connection - may cause a short circuit.
• 🚫 Ignoring the rubber seal - leads to moisture entering the door and corrosion.

Adjusting and tuning the mirror after replacement

If your mirror is powered, it will need to be calibrated after installation. To do this:

1. Turn on the ignition.

2. Press and hold the mirror adjustment button in the lowest position for 5 seconds.

3. The mirror will automatically move to the neutral position. After that, you can customize it for yourself.

For manually adjustable mirrors:

• 🔧 Use the lever under the glass to set the optimal viewing angle.
• 📐 Correct setting: should be visible in the mirror 1/4 rear fender and the entire lane behind.

If the mirror vibrates at speeds above 100 km/h, check:

• 🔩 Tightening the fastening bolts;
• 🪟 Integrity of glass (cracks can cause resonance);
• 🚗 Wheel balance - sometimes mirror vibration is associated with an imbalance of the front right wheel.

💡

After replacing the mirror, be sure to check the door tightness. Water the door with a hose - if water gets inside, the rubber seal needs to be replaced.

Mirror repair: when can it be restored and when can it only be replaced?

A damaged mirror does not always need to be completely replaced. In some cases, repairs are possible:

Problem	Can it be repaired?	Repair cost, rubles
Crack in glass	Yes (glass replacement)	1 500–3 000
Heating does not work	Yes (replacement of heating element)	2 000–4 000
Broken adjustment mechanism	Partially (depending on the model)	3 000–6 000
Crack in the body	No (replacement only)	—

To replace mirror glass you will need:

• 🔧 Hair dryer (to soften the glue);
• 🔧 New glass (item 6Y1857515 for versions without heating);
• 🔧 Auto glass adhesive (for example, 3M 08609).

Process:

1. Heat the edge of the glass with a hairdryer to soften the glue.
2. Carefully pry off the glass with a plastic puller.
3. Clean the case of old glue with acetone.
4. Apply new glue and press the glass for 10-15 minutes.

What to do if there are streaks left after replacing the glass?

Streaks appear due to glue getting on the reflective surface. They can be removed with alcohol or a special glass cleaner (for example, Sonax Glass Cleaner). If streaks remain, the glass will have to be replaced again.

Where to buy spare parts: trusted sellers and dismantling shops

When purchasing a mirror for Škoda Fabia 2 We recommend the following trusted sources:

• 🛒 Official Škoda dealers - warranty on original parts, but high price.
• 🛒 Exist.ru — wide selection of analogues, convenient selection by VIN.
• 🛒 Car disassembly:
  • Skoda-Parts.ru (Moscow, St. Petersburg);
  • Bamper.by (Minsk, delivery throughout the CIS);
  • Autopiter.ru (showdown in St. Petersburg).
• 🛒 AliExpress - cheap Chinese analogues (for example, mirror glass for 800–1,200 rubles), but the quality varies.

When purchasing a used mirror, be sure to check:

• 🔍 Condition of the plastic (are there any cracks);
• 🔌 Efficiency of heating and adjustment;
• 📅 Year of issue Fabia 2, from which the mirror was removed (pre-restyle or restyle).

⚠️ Attention: At disassembly sites they often sell mirrors from Škoda Roomster or VW Polo Sedan under the guise of parts for Fabia 2. They don't fit!

FAQ: Frequently asked questions about the right mirror Škoda Fabia 2

Is it possible to install a mirror from Fabia 3 on Fabia 2?

No, the mirrors are from Fabia 3 (2014–present) have a different mounting and shape. They are not compatible with Fabia 2 without major modifications to the door.

How to check if the heated mirror is working?

Turn on the ignition and press the heated rear window button (usually it is combined with heated mirrors). After 1-2 minutes, gently touch the glass of the mirror - it should be warm. If not, check the fuse F30 and wiring integrity.

What to do if the mirror is not adjustable with buttons?

Check the fuse first F30 (10A). If it is OK, remove the door trim and check:

• integrity of wires from the mirror to the control unit;
• oxidation of contacts in the connector;
• motor performance (supply 12V directly to it).

If the motor does not work, it can be replaced separately (part number 6Y1957581).

How to remove mirror glass if it is glued?

To do this:

1. Heat the glass with a hairdryer (temperature 60–80°C) for 2–3 minutes.
2. Gently pry it open with a plastic spatula or guitar pick.
3. Clean the housing from any adhesive residue with a solvent (for example, White spirit).

Glue the new glass with double-sided tape 3M VHB or special glue for auto glass.

Why does the right mirror on the Fabia 2 quickly become covered with condensation?

This is a typical problem with non-heated mirrors. Solutions:

• install heated glass (article no. 6Y1857515B);
• treat the inner surface of the glass with an anti-fog agent (for example, Sonax Anti-Fog);
• Check the door seal - perhaps moisture is getting inside.